BMC156 is very smilar to BMC150, but it has only one accelerometer
interrupt pin. It would make sense if only INT1 was exposed but someone
at Bosch was crazy and decided to only have an INT2 pin.

In this case, it does not make sense if the first interrupt pin is
treated as INT1 (since that pin does not exist). Add a note to the
bindings that the first interrupt pin is treated as INT2 for BMC156.

Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
---
 .../bindings/iio/accel/bosch,bma255.yaml       | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/Documentation/devicetree/bindings/iio/accel/bosch,bma255.yaml b/Documentation/devicetree/bindings/iio/accel/bosch,bma255.yaml
index 897a1d808ef5..f7848e4a7b29 100644
--- a/Documentation/devicetree/bindings/iio/accel/bosch,bma255.yaml
+++ b/Documentation/devicetree/bindings/iio/accel/bosch,bma255.yaml

@@ -26,6 +26,7 @@ properties:
       - bosch,bma255
       - bosch,bma280
       - bosch,bmc150_accel
+      - bosch,bmc156_accel
       - bosch,bmi055_accel
 
       # bma180 driver in Linux

@@ -49,6 +50,9 @@ properties:
       the second (optional) interrupt listed must be the one connected to the
       INT2 pin (if available). The type should be IRQ_TYPE_EDGE_RISING.
 
+      BMC156 does not have an INT1 pin, therefore the first interrupt pin is
+      always treated as INT2.

+
   interrupt-names:
     minItems: 1
     maxItems: 2

@@ -84,6 +88,20 @@ examples:
             interrupt-names = "INT1";
         };
     };
+  - |
+    #include <dt-bindings/interrupt-controller/irq.h>
+    i2c {
+        #address-cells = <1>;
+        #size-cells = <0>;
+        accelerometer@10 {
+            compatible = "bosch,bmc156_accel";
+            reg = <0x10>;
+            vddio-supply = <&vddio>;
+            vdd-supply = <&vdd>;
+            interrupts = <116 IRQ_TYPE_EDGE_RISING>;
+            interrupt-names = "INT2";
+        };
+    };
   - |
     # include <dt-bindings/interrupt-controller/irq.h>
     spi {