Re: [PATCH v4 0/4] Add DT bindings and DT nodes for PCIe and PHY in SC7280

[+cc linux-pci]

On Fri, Jul 16, 2021 at 07:28:43PM +0530, Prasad Malisetty wrote:

Changes in v4 as suggested by Bjorn:

	* Changed pipe clk mux name as gcc_pcie_1_pipe_clk_src.
	* Changed pipe_ext_src as phy_pipe_clk.
	* Updated commit message for [PATCH v4 4/4]. 
		

Changes in v3:
	* Changed pipe clock names in dt bindings as pipe_mux and phy_pipe.
	* Moved reset and NVMe GPIO pin configs into board specific file.
	* Updated pipe clk mux commit message.
	
Changes in v2:
	* Moved pcie pin control settings into IDP file.
	* Replaced pipe_clk_src with pipe_clk_mux in pcie driver 
	* Included pipe clk mux setting change set in this series

Prasad Malisetty (4):
  dt-bindings: pci: qcom: Document PCIe bindings for SC720
  arm64: dts: qcom: sc7280: Add PCIe and PHY related nodes
  arm64: dts: qcom: sc7280: Add PCIe nodes for IDP board
  PCIe: qcom: Add support to control pipe clk src

 .../devicetree/bindings/pci/qcom,pcie.txt          |  17 +++
 arch/arm64/boot/dts/qcom/sc7280-idp.dts            |  38 +++++++
 arch/arm64/boot/dts/qcom/sc7280.dtsi               | 125 +++++++++++++++++++++
 drivers/pci/controller/dwc/pcie-qcom.c             |  22 ++++

  $ ./scripts/get_maintainer.pl -f drivers/pci/controller/dwc/pcie-qcom.c

tells you that linux-pci should be included.  One reason that's
important is because patchwork watches linux-pci for incoming patches,
and I use patchwork as my to-do list.