On Thu, Jun 10, 2021 at 01:29:26PM +0300, Andy Shevchenko wrote:

On Thu, Jun 10, 2021 at 12:56 PM Stephan Gerhold [off-list ref] wrote:

quoted

The Bosch BMA253 accelerometer is very similar to both BMA254 and BMA255.
The current situation is very confusing: BMA254 is supported by the bma180
driver, but BMA255 is supported by the bmc150-accel driver.

It turns out the bma180 and bmc150-accel drivers have quite some overlap,
and BMA253/BMA254 would be a bit better supported in bmc150
(which has support for the motion trigger/interrupt).

This series adds BMA253 support to bmc150-accel and also moves BMA254
over to bmc150, removing some unnecessary code from the bma180 driver.

I asked Linus Walleij to test these patches on BMA254 a while ago
and he suggested that I already add his Reviewed-by.

I add


After addressing comments per patch 1, feel free to add my
Reviewed-by: Andy Shevchenko <redacted>
to the series.

Thanks for the review!

I think the re-ordering should be a separate commit to make the diff not
too confusing. Is it fine for you if I send that as a follow-up patch?
I already have two more patches that would conflict with the reordering,
so it would be easier to include that in the next series.

But I can also re-send the entire series with the extra patch if you
prefer that, just let me know. :)

And I guess you can drop Laurentiu Palcu email because most of those
sensor drivers were done by an Intel team that is not at the company
anymore for a few years.

Oh yeah, got a lot of mails that it couldn't be delivered to Laurentiu.
Oh well.

Thanks,
Stephan