[PATCH v2 1/3] dt-bindings: mmc: add no-mmc-hs400 flag
From: Lucas Stach <l.stach@pengutronix.de>
Date: 2021-05-10 19:11:46
Also in:
linux-arm-kernel, linux-mmc
Subsystem:
multimedia card (mmc), secure digital (sd) and sdio subsystem, open firmware and flattened device tree bindings, the rest · Maintainers:
Ulf Hansson, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
From: Lucas Stach <dev@lynxeye.de> HS400 requires a data strobe line in addition to the usual MMC signal lines. If a board design neglects to wire up this signal, HS400 mode is not available, even if both the controller and the eMMC are claiming to support this mode. Add a DT flag to allow boards to disable the HS400 support in this case. Signed-off-by: Lucas Stach <dev@lynxeye.de> Acked-by: Rob Herring <robh@kernel.org> --- Documentation/devicetree/bindings/mmc/mmc-controller.yaml | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/mmc/mmc-controller.yaml b/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
index e141330c1114..ac80d09df3a9 100644
--- a/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
+++ b/Documentation/devicetree/bindings/mmc/mmc-controller.yaml@@ -220,6 +220,11 @@ properties: description: eMMC HS400 enhanced strobe mode is supported + no-mmc-hs400: + $ref: /schemas/types.yaml#/definitions/flag + description: + All eMMC HS400 modes are not supported. + dsr: description: Value the card Driver Stage Register (DSR) should be programmed
--
2.31.1