[RFC PATCH net-next v5 21/25] devicetree: bindings: dsa: qca8k: Document internal mdio definition
From: Ansuel Smith <ansuelsmth@gmail.com>
Date: 2021-05-11 02:09:57
Also in:
lkml, netdev
Subsystem:
networking drivers, networking [dsa], open firmware and flattened device tree bindings, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Andrew Lunn, Vladimir Oltean, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document new way of declare mapping of internal PHY to port. The new implementation directly declare the PHY connected to the port by adding a node in the switch node. The driver detect this and register an internal mdiobus using the mapping defined in the mdio node. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> --- .../devicetree/bindings/net/dsa/qca8k.txt | 39 +++++++++++++++++++ 1 file changed, 39 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/dsa/qca8k.txt b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
index 1daf68e7ae19..3973a9d3e426 100644
--- a/Documentation/devicetree/bindings/net/dsa/qca8k.txt
+++ b/Documentation/devicetree/bindings/net/dsa/qca8k.txt@@ -21,6 +21,10 @@ described in dsa/dsa.txt. If the QCA8K switch is connect to a SoC's external mdio-bus each subnode describing a port needs to have a valid phandle referencing the internal PHY it is connected to. This is because there's no N:N mapping of port and PHY id. +To declare the internal mdio-bus configuration, declare a mdio node in the +switch node and declare the phandle for the port referencing the internal +PHY is connected to. In this config a internal mdio-bus is registred and +the mdio MASTER is used as communication. Don't use mixed external and internal mdio-bus configurations, as this is not supported by the hardware.
@@ -150,26 +154,61 @@ for the internal master mdio-bus configuration: port@1 { reg = <1>; label = "lan1"; + phy-mode = "internal"; + phy-handle = <&phy_port1>; }; port@2 { reg = <2>; label = "lan2"; + phy-mode = "internal"; + phy-handle = <&phy_port2>; }; port@3 { reg = <3>; label = "lan3"; + phy-mode = "internal"; + phy-handle = <&phy_port3>; }; port@4 { reg = <4>; label = "lan4"; + phy-mode = "internal"; + phy-handle = <&phy_port4>; }; port@5 { reg = <5>; label = "wan"; + phy-mode = "internal"; + phy-handle = <&phy_port5>; + }; + }; + + mdio { + #address-cells = <1>; + #size-cells = <0>; + + phy_port1: phy@0 { + reg = <0>; + }; + + phy_port2: phy@1 { + reg = <1>; + }; + + phy_port3: phy@2 { + reg = <2>; + }; + + phy_port4: phy@3 { + reg = <3>; + }; + + phy_port5: phy@4 { + reg = <4>; }; }; };
--
2.30.2