[PATCH 10/18] arm64: dts: qcom: msm8994-octagon: Configure HD3SS460 Type-C mux pins
From: Konrad Dybcio <hidden>
Date: 2021-01-31 01:45:04
Also in:
linux-arm-msm, lkml, phone-devel
Subsystem:
arm/qualcomm mailing list, arm/qualcomm support, the rest · Maintainers:
Bjorn Andersson, Konrad Dybcio, Linus Torvalds
From: Gustave Monce <redacted> The driver is not available yet, so hardcode the pins. Signed-off-by: Gustave Monce <redacted> Signed-off-by: Konrad Dybcio <redacted> --- .../dts/qcom/msm8994-msft-lumia-octagon.dtsi | 31 +++++++++++++++++++ 1 file changed, 31 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/msm8994-msft-lumia-octagon.dtsi b/arch/arm64/boot/dts/qcom/msm8994-msft-lumia-octagon.dtsi
index 78443f5a3881..bf6e63a23600 100644
--- a/arch/arm64/boot/dts/qcom/msm8994-msft-lumia-octagon.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8994-msft-lumia-octagon.dtsi@@ -337,6 +337,37 @@ pinconf { }; }; +&pmi8994_gpios { + pinctrl-0 = <&hd3ss460_pol &hd3ss460_amsel &hd3ss460_en>; + pinctrl-names = "default"; + + /* + * This device uses a TI HD3SS460 Type-C MUX + * As this device has no driver currently, + * the configuration for USB Face Up is set-up here. + * + * TODO: remove once a driver is available + * TODO: add VBUS GPIO 5 + */ + hd3ss460_pol: pol_low { + pins = "gpio8"; + drive-strength = <3>; + bias-pull-down; + }; + + hd3ss460_amsel: amsel_high { + pins = "gpio9"; + drive-strength = <1>; + bias-pull-up; + }; + + hd3ss460_en: en_high { + pins = "gpio10"; + drive-strength = <1>; + bias-pull-up; + }; +}; + &pmi8994_spmi_regulators { vdd_gfx: s2@1700 { reg = <0x1700 0x100>;
--
2.30.0