[PATCH v2 4/4] arm64: dts: allwinner: h6: Use RSB for AXP805 PMIC connection

From: Samuel Holland <samuel@sholland.org>
Date: 2021-01-03 10:01:14
Also in: linux-arm-kernel, linux-clk, linux-gpio, lkml
Subsystem: arm/allwinner sunxi soc support, the rest · Maintainers: Chen-Yu Tsai, Jernej Skrabec, Samuel Holland, Linus Torvalds

On boards where the only peripheral connected to PL0/PL1 is an X-Powers
PMIC, configure the connection to use the RSB bus rather than the I2C
bus. Compared to the I2C controller that shares the pins, the RSB
controller allows a higher bus frequency, and it is more CPU-efficient.

Signed-off-by: Samuel Holland <samuel@sholland.org>
---
 .../dts/allwinner/sun50i-h6-beelink-gs1.dts   | 38 +++++++++----------
 .../dts/allwinner/sun50i-h6-orangepi-3.dts    | 14 +++----
 .../dts/allwinner/sun50i-h6-orangepi.dtsi     | 22 +++++------
 3 files changed, 37 insertions(+), 37 deletions(-)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts b/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts
index 7c9dbde645b5..3452add30cc4 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts

@@ -150,12 +150,28 @@ &pio {
 	vcc-pg-supply = <&reg_aldo1>;
 };
 
-&r_i2c {
+&r_ir {
+	linux,rc-map-name = "rc-beelink-gs1";
+	status = "okay";
+};
+
+&r_pio {
+	/*
+	 * FIXME: We can't add that supply for now since it would
+	 * create a circular dependency between pinctrl, the regulator
+	 * and the RSB Bus.
+	 *
+	 * vcc-pl-supply = <&reg_aldo1>;
+	 */
+	vcc-pm-supply = <&reg_aldo1>;
+};
+
+&r_rsb {
 	status = "okay";
 
-	axp805: pmic@36 {
+	axp805: pmic@745 {
 		compatible = "x-powers,axp805", "x-powers,axp806";
-		reg = <0x36>;
+		reg = <0x745>;
 		interrupt-parent = <&r_intc>;
 		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
 		interrupt-controller;

@@ -273,22 +289,6 @@ sw {
 	};
 };
 
-&r_ir {
-	linux,rc-map-name = "rc-beelink-gs1";
-	status = "okay";
-};
-
-&r_pio {
-	/*
-	 * PL0 and PL1 are used for PMIC I2C
-	 * don't enable the pl-supply else
-	 * it will fail at boot
-	 *
-	 * vcc-pl-supply = <&reg_aldo1>;
-	 */
-	vcc-pm-supply = <&reg_aldo1>;
-};
-
 &rtc {
 	clocks = <&ext_osc32k>;
 };

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
index 15c9dd8c4479..16702293ac0b 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts

@@ -175,12 +175,16 @@ &pio {
 	vcc-pg-supply = <&reg_vcc_wifi_io>;
 };
 
-&r_i2c {
+&r_ir {
+	status = "okay";
+};
+
+&r_rsb {
 	status = "okay";
 
-	axp805: pmic@36 {
+	axp805: pmic@745 {
 		compatible = "x-powers,axp805", "x-powers,axp806";
-		reg = <0x36>;
+		reg = <0x745>;
 		interrupt-parent = <&r_intc>;
 		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
 		interrupt-controller;

@@ -291,10 +295,6 @@ sw {
 	};
 };
 
-&r_ir {
-	status = "okay";
-};
-
 &rtc {
 	clocks = <&ext_osc32k>;
 };

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
index ebc120a9232f..23e3cb2ffd8d 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi

@@ -112,12 +112,20 @@ &pio {
 	vcc-pg-supply = <&reg_aldo1>;
 };
 
-&r_i2c {
+&r_ir {
+	status = "okay";
+};
+
+&r_pio {
+	vcc-pm-supply = <&reg_bldo3>;
+};
+
+&r_rsb {
 	status = "okay";
 
-	axp805: pmic@36 {
+	axp805: pmic@745 {
 		compatible = "x-powers,axp805", "x-powers,axp806";
-		reg = <0x36>;
+		reg = <0x745>;
 		interrupt-parent = <&r_intc>;
 		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
 		interrupt-controller;

@@ -232,14 +240,6 @@ sw {
 	};
 };
 
-&r_ir {
-	status = "okay";
-};
-
-&r_pio {
-	vcc-pm-supply = <&reg_bldo3>;
-};
-
 &rtc {
 	clocks = <&ext_osc32k>;
 };

-- 
2.26.2

`h`	back out one level
`j`	next message in thread
`k`	previous message in thread
`l`	drill in
`Esc`	close help / fold thread tree
`?`	toggle this help