[PATCH v3 14/15] ARM: dts: sun8i: a83t: Add MIPI CSI-2 controller node
From: Paul Kocialkowski <hidden>
Date: 2020-12-11 17:11:07
Also in:
linux-arm-kernel, linux-doc, linux-media, lkml
Subsystem:
the rest · Maintainer:
Linus Torvalds
MIPI CSI-2 is supported on the A83T with a dedicated controller that covers both the protocol and D-PHY. It can be connected to the CSI interface as a V4L2 subdev through the fwnode graph. This is not done by default since connecting the bridge without a subdev attached to it will cause a failure on the CSI driver. Signed-off-by: Paul Kocialkowski <redacted> --- arch/arm/boot/dts/sun8i-a83t.dtsi | 26 ++++++++++++++++++++++++++ 1 file changed, 26 insertions(+)
diff --git a/arch/arm/boot/dts/sun8i-a83t.dtsi b/arch/arm/boot/dts/sun8i-a83t.dtsi
index c010b27fdb6a..d6d55c12b995 100644
--- a/arch/arm/boot/dts/sun8i-a83t.dtsi
+++ b/arch/arm/boot/dts/sun8i-a83t.dtsi@@ -1066,6 +1066,32 @@ csi_in: port { }; }; + mipi_csi2: csi@1cb1000 { + compatible = "allwinner,sun8i-a83t-mipi-csi2"; + reg = <0x01cb1000 0x1000>; + interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&ccu CLK_BUS_CSI>, + <&ccu CLK_CSI_SCLK>, + <&ccu CLK_MIPI_CSI>, + <&ccu CLK_CSI_MISC>; + clock-names = "bus", "mod", "mipi", "misc"; + resets = <&ccu RST_BUS_CSI>; + status = "disabled"; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + mipi_csi2_in: port@0 { + reg = <0>; + }; + + mipi_csi2_out: port@1 { + reg = <1>; + }; + }; + }; + hdmi: hdmi@1ee0000 { compatible = "allwinner,sun8i-a83t-dw-hdmi"; reg = <0x01ee0000 0x10000>;
--
2.29.2