On Wed, Dec 09, 2020 at 05:04:59PM +0300, Ivan Mikhaylov wrote:

In KSZ9131 PHY it is possible to control LEDs blink behavior via
LED mode behavior and select registers. Add DTS properties plus handles
of them inside micrel PHY driver.

I've some concerns about passing raw register values into LED mode
select and behavior.

There was been some work done allowing PHY LEDs to be controlled just
like other LEDs in Linux. That is how this should be done. Please go
look back in the netdev and LED mailing list archives, and join that
work.

     Andrew