[PATCH v2 2/2] dt: bindings: ath10k: Document qcom,ath10k-pre-calibration-data-mtd
From: Ansuel Smith <ansuelsmth@gmail.com>
Date: 2020-09-18 18:11:32
Also in:
linux-wireless, lkml, netdev
Subsystem:
arm/qualcomm mailing list, networking drivers (wireless), open firmware and flattened device tree bindings, the rest · Maintainers:
Johannes Berg, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document use of qcom,ath10k-pre-calibration-data-mtd bindings used to define from where the driver will load the pre-cal data in the defined mtd partition. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> --- .../devicetree/bindings/net/wireless/qcom,ath10k.txt | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
index b61c2d5a0..568364243 100644
--- a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
+++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt@@ -15,9 +15,9 @@ and also uses most of the properties defined in this doc (except "qcom,ath10k-calibration-data"). It uses "qcom,ath10k-pre-calibration-data" to carry pre calibration data. -In general, entry "qcom,ath10k-pre-calibration-data" and -"qcom,ath10k-calibration-data" conflict with each other and only one -can be provided per device. +In general, entry "qcom,ath10k-pre-calibration-data", +"qcom,ath10k-calibration-data-mtd" and "qcom,ath10k-calibration-data" conflict with +each other and only one can be provided per device. SNOC based devices (i.e. wcn3990) uses compatible string "qcom,wcn3990-wifi".
@@ -63,6 +63,12 @@ Optional properties: hw versions. - qcom,ath10k-pre-calibration-data : pre calibration data as an array, the length can vary between hw versions. +- qcom,ath10k-pre-calibration-data-mtd : + Usage: optional + Value type: <phandle offset size> + Definition: pre calibration data read from mtd partition. Take 3 value, the + mtd to read data from, the offset in the mtd partition and the + size of data to read. - <supply-name>-supply: handle to the regulator device tree node optional "supply-name" are "vdd-0.8-cx-mx", "vdd-1.8-xo", "vdd-1.3-rfa", "vdd-3.3-ch0",
--
2.27.0