Hi Rob,

Thanks for the review.

-----Original Message-----
From: Rob Herring <robh@kernel.org>
Sent: Wednesday, September 9, 2020 4:35 AM
To: Manish Narani <redacted>
Cc: gregkh@linuxfoundation.org; Michal Simek <redacted>;
balbi@kernel.org; p.zabel@pengutronix.de; linux-usb@vger.kernel.org;
devicetree@vger.kernel.org; linux-arm-kernel@lists.infradead.org; linux-
kernel@vger.kernel.org; git [off-list ref]
Subject: Re: [PATCH 1/2] dt-bindings: usb: dwc3-xilinx: Add documentation for
Versal DWC3 Controller

On Thu, Aug 27, 2020 at 12:14:00AM +0530, Manish Narani wrote:

quoted

Add documentation for Versal DWC3 controller. Add required property
'reg' for the same. Also add optional properties for snps,dwc3.

Signed-off-by: Manish Narani <redacted>
---
 .../devicetree/bindings/usb/dwc3-xilinx.txt          | 12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/usb/dwc3-xilinx.txt

b/Documentation/devicetree/bindings/usb/dwc3-xilinx.txt

quoted

index 4aae5b2cef56..dd41ed831411 100644

--- a/Documentation/devicetree/bindings/usb/dwc3-xilinx.txt
+++ b/Documentation/devicetree/bindings/usb/dwc3-xilinx.txt

@@ -1,7 +1,8 @@
 Xilinx SuperSpeed DWC3 USB SoC controller

 Required properties:
-- compatible:	Should contain "xlnx,zynqmp-dwc3"
+- compatible:	May contain "xlnx,zynqmp-dwc3" or "xlnx,versal-

dwc3"

quoted

+- reg:		Base address and length of the register control block
 - clocks:	A list of phandles for the clocks listed in clock-names
 - clock-names:	Should contain the following:
   "bus_clk"	 Master/Core clock, have to be >= 125 MHz for SS

@@ -13,12 +14,19 @@ Required child node:
 A child node must exist to represent the core DWC3 IP block. The name of
 the node is not important. The content of the node is defined in dwc3.txt.

+Optional properties for snps,dwc3:
+- dma-coherent:	Enable this flag if CCI is enabled in design. Adding this
+		flag configures Global SoC bus Configuration Register and
+		Xilinx USB 3.0 IP - USB coherency register to enable CCI.
+- interrupt-names: This property provides the names of the interrupt ids

used

You have to define what the names are. 'dwc_usb3' seems pretty pointless
if only 1 name.

OK. I am planning to add more interrupt ids going ahead. For now I will remove
this interrupt name in v2. The interrupt name will be added along with other interrupt
names.

Thanks,
Manish