Hi.

The first part is to document DT bindings for Keem Bay eMMC PHY.

The second is the driver file, loosely based on phy-rockchip-emmc.c
and phy-intel-emmc.c. The latter is not being reused as there are
quite a number of differences i.e. registers offset, supported clock
rates, bitfield to set.

The patch was tested with Keem Bay evaluation module board.

Thank you.

Best regards,
Zainie

Changes since v4:
- In Kconfig file, add depends on ARM64 || COMPILE_TEST and
  depends on OF && HAS_IOMEM.
- In Kconfig file, reword the help section to be more verbose.

Changes since v3:
- Exit keembay_emmc_phy_power() with return ret;.
- In keembay_emmc_phy_init(), use PTR_ERR_OR_ZERO(...).
- In keembay_emmc_phy_probe(), devm_regmap_init_mmio(...) in single
  line.

Changes since v2:
- Modify DT example to use single cell for address and size.

Changes since v1:
- Rework phy-keembay-emmc.c to make it similar to phy-intel-emmc.c.
- Use regmap_mmio, and remove reference to intel,syscon.
- Use node name phy@....
- Update license i.e. use dual license.


Wan Ahmad Zainie (2):
  dt-bindings: phy: intel: Add Keem Bay eMMC PHY bindings
  phy: intel: Add Keem Bay eMMC PHY support

 .../bindings/phy/intel,keembay-emmc-phy.yaml  |  45 +++
 drivers/phy/intel/Kconfig                     |  12 +
 drivers/phy/intel/Makefile                    |   1 +
 drivers/phy/intel/phy-keembay-emmc.c          | 316 ++++++++++++++++++
 4 files changed, 374 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/phy/intel,keembay-emmc-phy.yaml
 create mode 100644 drivers/phy/intel/phy-keembay-emmc.c

-- 
2.17.1