On 5/27/20 9:52 AM, Serge Semin wrote:

On Wed, May 27, 2020 at 09:25:49AM -0700, Guenter Roeck wrote:

quoted

On Tue, May 26, 2020 at 04:38:23PM +0300, Serge Semin wrote:

[nip]

quoted

quoted

+
+=============================== ======= =======================================
+Name				Perm	Description
+=============================== ======= =======================================
+update_interval			RW	Measurements update interval per
+					sensor.
+temp1_type			RO	Sensor type (always 1 as CPU embedded
+					diode).
+temp1_label			RO	CPU Core Temperature sensor.
+temp1_input			RO	Measured temperature in millidegree
+					Celsius.
+temp1_min			RW	Low limit for temp input.
+temp1_max			RW	High limit for temp input.
+temp1_min_alarm			RO	Temperature input alarm. Returns 1 if
+					temperature input went below min limit,
+					0 otherwise.
+temp1_max_alarm			RO	Temperature input alarm. Returns 1 if
+					temperature input went above max limit,
+					0 otherwise.
+temp1_trim			RW	Temperature sensor trimming factor in
+					millidegree Celsius. It can be used to
+					manually adjust the temperature
+					measurements within 7.130 degrees
+					Celsius.

vs. standard ABI:

temp[1-*]_offset`
                Temperature offset which is added to the temperature reading
                by the chip.

                Unit: millidegree Celsius

If you really think this is necessary, why not use the standard ABI ?

That would have made much more sense.) I'll replace the handwritten temp1_trim
with the standard temp1_offset attribute in v4 shortly today. Thanks for pointing
this out.

Sorry for not realizing this earlier. The added explanation
made all the difference.

Guenter