Re: [PATCH] pinctrl: at91: Enable slewrate by default on SAM9X60

On SAM9X60, slewrate should be enabled on pins with a switching frequency
below 50Mhz. Since most of our pins do not exceed this value, we enable
slewrate by default. Pins with a switching value that exceeds 50Mhz will
have to explicitly disable slewrate.

Suggested-by: Ludovic Desroches <ludovic.desroches@microchip.com>
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
---
 drivers/pinctrl/pinctrl-at91.c     | 4 ++--
 include/dt-bindings/pinctrl/at91.h | 4 ++--
 2 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-at91.c b/drivers/pinctrl/pinctrl-at91.c
index 117075b5798f..c135149e84e9 100644
--- a/drivers/pinctrl/pinctrl-at91.c
+++ b/drivers/pinctrl/pinctrl-at91.c

@@ -85,8 +85,8 @@ enum drive_strength_bit {
 					 DRIVE_STRENGTH_SHIFT)
 
 enum slewrate_bit {
-	SLEWRATE_BIT_DIS,
 	SLEWRATE_BIT_ENA,
+	SLEWRATE_BIT_DIS,
 };
 
 #define SLEWRATE_BIT_MSK(name)		(SLEWRATE_BIT_##name << SLEWRATE_SHIFT)

@@ -669,7 +669,7 @@ static void at91_mux_sam9x60_set_slewrate(void __iomem *pio, unsigned pin,
 {
 	unsigned int tmp;
 
-	if (setting < SLEWRATE_BIT_DIS || setting > SLEWRATE_BIT_ENA)
+	if (setting < SLEWRATE_BIT_ENA || setting > SLEWRATE_BIT_DIS)
 		return;
 
 	tmp = readl_relaxed(pio + SAM9X60_PIO_SLEWR);

diff --git a/include/dt-bindings/pinctrl/at91.h b/include/dt-bindings/pinctrl/at91.h
index 3831f91fb3ba..e8e117306b1b 100644
--- a/include/dt-bindings/pinctrl/at91.h
+++ b/include/dt-bindings/pinctrl/at91.h

@@ -27,8 +27,8 @@
 #define AT91_PINCTRL_DRIVE_STRENGTH_MED			(0x2 << 5)
 #define AT91_PINCTRL_DRIVE_STRENGTH_HI			(0x3 << 5)
 
-#define AT91_PINCTRL_SLEWRATE_DIS	(0x0 << 9)
-#define AT91_PINCTRL_SLEWRATE_ENA	(0x1 << 9)
+#define AT91_PINCTRL_SLEWRATE_ENA	(0x0 << 9)
+#define AT91_PINCTRL_SLEWRATE_DIS	(0x1 << 9)