Hi Scott,
On Friday, October 25, 2019 02:34, Scott Wood wrote
On Mon, 2019-10-21 at 11:49 +0800, Ran Wang wrote:
quoted
By default, QorIQ SoC's RCPM register block is Big Endian. But there
are some exceptions, such as LS1088A and LS2088A, are Little Endian.
So add this optional property to help identify them.
Actually LS2021A and other Layerscapes won't totally follow Chassis
2.1, so separate them from powerpc SoC.
Did you mean LS1021A and "don't" instead of "won't", given the change to the
examples?
OK, I will change it to don't to just tel current situation.
quoted
Change in v5:
- Add 'Reviewed-by: Rob Herring [off-list ref]' to commit
message.
quoted
- Rename property 'fsl,#rcpm-wakeup-cells' to '#fsl,rcpm-wakeup-
cells'.
please see https://lore.kernel.org/patchwork/patch/1101022/
I'm not sure why Rob considers this the "correct form" -- there are other
examples of the current form, such as ibm,#dma-address-cells and ti,#tlb-
entries, and the current form makes more logical sense (# is part of the property
name, not the vendor). Oh well.
quoted
Required properites:
- reg : Offset and length of the register set of the RCPM block.
- - fsl,#rcpm-wakeup-cells : The number of IPPDEXPCR register cells
in the
+ - #fsl,rcpm-wakeup-cells : The number of IPPDEXPCR register cells
+ in the
fsl,rcpm-wakeup property.
- compatible : Must contain a chip-specific RCPM block compatible string
and (if applicable) may contain a chassis-version RCPM compatible @@
-20,6 +20,7 @@ Required properites:
* "fsl,qoriq-rcpm-1.0": for chassis 1.0 rcpm
* "fsl,qoriq-rcpm-2.0": for chassis 2.0 rcpm
* "fsl,qoriq-rcpm-2.1": for chassis 2.1 rcpm
+ * "fsl,qoriq-rcpm-2.1+": for chassis 2.1+ rcpm
Is there something actually called "2.1+"? It looks a bit like an attempt to claim
compatibility with all future versions. If the former, is it a name that comes
from the hardware side with an intent for it to describe a stable interface, or are
we later going to see a patch changing some by-then-existing device trees from
"2.1+" to "2.1++" when some new incompatibility is found?
Perhaps it would be better to bind to the specific chip compatibles.
According to SoC data sheets, powerPC SoC T1040 and current ARM based Layerscape
SoCs (LS1021A, LS1012A, LS1043A, etc)'s arch designs are both basing on Chassis spec 2.1.
However, for Layerscape, their data sheets are also explicitly telling that some minor
changes have been made(basing on Chassis 2.1 spec). And in parallel, the SW arch designs
between T1040 and Layerscape family are also different: For Layerscape, part of RCPM
programming job has been moved from kernel driver to firmware/bootloader (through
PSCI interface). That's why I have to name a new compatible string to distinguish them.
They cannot use the same driver. I don’t think we will add another sting like 2.1++ in the
future. If the Chassis spec keep evolving and requiring different programming logic,
we can add more like 3.0, 4.0, ..., I think.
Regards,
Ran