Re: [RFC PATCH v2 1/5] mtd: cfi_cmdset_0002: Add support for polling status register

From
Joakim Tjernlund <hidden>
Date
2019-03-21 18:11:08
Also in
linux-arm-kernel, lkml
Reply to
Vignesh Raghavendra, 2019-03-21
On Thu, 2019-03-21 at 23:15 +0530, Vignesh Raghavendra wrote:
HyperFlash devices are compliant with CFI AMD/Fujitsu Extended Command
Set(0x0002) for flash operations, therefore drivers/mtd/chips/cfi_cmdset_0002.c
can be use as is. But these devices do not support DQ polling method of
determining chip ready/good status. These flashes provide Status
Register whose bits can be polled to know status of flash operation.

Cypress HyperFlash datasheet here[1], talks about CFI Amd/Fujitsu
Extended Query version 1.5. Bit 0 of "Software Features supported" field
of CFI Primary Vendor-Specific Extended Query table indicates
presence/absence of status register and Bit 1 indicates whether or not
DQ polling is supported. Using these bits, its possible to determine
whether flash supports DQ polling or need to use Status Register.

Add support for polling status register to know device ready/status of
erase/write operations when DQ polling is not supported.
Isn't this new Status scheme just a copy of Intels(cmdset_0001)?
If so I think the new status impl. in 0002 should borrow from 0001 as this is a
hardened and battle tested impl.

I know other modern 0002 chips supports both old and new impl. of Status and I world
guess that we will see more chips with new Status only.

 Jocke
Thread (18 messages) 18 messages, 3 authors, last reply 2019-04-02
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help