Hi Bin,

Thanks for your help.

Hi Rob,

I find that Samsung describes the usb-connector attribute in DTS, and
uses a private driver.
And try to write DTS as following:

usb-connector node:
musb_con: musb_connector{
    compatible = "linux,extcon-usb-gpio","usb-b-connector";
    lable = "micro-USB";
    type = "micro";
    id-gpio = <&pio 44 GPIO_ACTIVE_HIGH>
    vbus-supply = <&usb_vbus>;
    port {
        usb_to_connector: endpoint {
            remote-endpoint = <&connector_to_usb>;
        };
    };
};

usb node:
&usb2{
    status = "okay";
    port {
        connector_to_usb: endpoint {
            remote-endpoint = <&usb_to_connector>;
        };
    };
}

Can I describe usb-connector like this? Or can you give me some advices?

Regards,
Min.

On Tue, 2019-01-22 at 08:33 -0600, Bin Liu wrote:

Hi Min,

On Tue, Jan 22, 2019 at 05:36:13PM +0800, Min Guo wrote:

quoted

Hi Bin,

Sorry to bother you again, I encounter a problem about the extcon
property.

I don't find a common driver describing the usb-connector. Is
there any driver that I can refer to, specially the way to switch MUSB
controller between host and device mode? 
If it needs to implement by myself, is it possible to emulate an
usb-connector driver by extcon-usb-gpio, and also use the notifier
mechanism or can you give me some advices?

I am afraid I am unable to help you on this. I wasn't really pay
attention when usb-connector was introduced and not sure how it can
replace extcon. Now after read usb-connector.txt, it seems the binding
only defines a/b/c-connector, but not ab-connector, and there is no
enough information (at least for me) explaining how VBUS and ID fix into
this usb-connector binding.

Maybe Rob can provide some hint.

Regards,
-Bin.