[PATCH 02/12] media: i2c: mt9m001: dt: add binding for mt9m001
From: Akinobu Mita <akinobu.mita@gmail.com>
Date: 2018-12-22 17:12:44
Also in:
linux-media
Subsystem:
media input infrastructure (v4l/dvb), open firmware and flattened device tree bindings, the rest · Maintainers:
Mauro Carvalho Chehab, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Add device tree binding documentation for the MT9M001 CMOS image sensor. Cc: Rob Herring <robh@kernel.org> Cc: Guennadi Liakhovetski <redacted> Cc: Sakari Ailus <sakari.ailus@linux.intel.com> Cc: Mauro Carvalho Chehab <redacted> Signed-off-by: Akinobu Mita <akinobu.mita@gmail.com> --- .../devicetree/bindings/media/i2c/mt9m001.txt | 37 ++++++++++++++++++++++ 1 file changed, 37 insertions(+) create mode 100644 Documentation/devicetree/bindings/media/i2c/mt9m001.txt
diff --git a/Documentation/devicetree/bindings/media/i2c/mt9m001.txt b/Documentation/devicetree/bindings/media/i2c/mt9m001.txt
new file mode 100644
index 0000000..794b787
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/mt9m001.txt@@ -0,0 +1,37 @@ +MT9M001: 1/2-Inch Megapixel Digital Image Sensor + +The MT9M001 is an SXGA-format with a 1/2-inch CMOS active-pixel digital +image sensor. It is programmable through a simple two-wire serial +interface. + +Required Properties: + +- compatible: shall be "onnn,mt9m001". +- clocks: reference to the master clock into sensor + +Optional Properties: + +- reset-gpios: GPIO handle which is connected to the reset pin of the chip. + Active low. +- standby-gpios: GPIO handle which is connected to the standby pin of the chip. + Active high. + +For further reading on port node refer to +Documentation/devicetree/bindings/media/video-interfaces.txt. + +Example: + + &i2c1 { + mt9m001@5d { + compatible = "onnn,mt9m001"; + reg = <0x5d>; + reset-gpios = <&gpio0 0 GPIO_ACTIVE_LOW>; + standby-gpios = <&gpio0 1 GPIO_ACTIVE_HIGH>; + clocks = <&camera_clk>; + port { + mt9m001_out: endpoint { + remote-endpoint = <&vcap_in>; + }; + }; + }; + };
--
2.7.4