So far the PHY ->xlate() callback was checking if the port was
"invalid" before continuing, meaning that the port has not been used
yet. This check is not correct as there is no opposite call to
->xlate() once the PHY is released by the user and the port will
remain "valid" after the first phy_get()/phy_put() calls. Hence, if
this driver is built as a module, inserted, removed and inserted
again, the PHY will appear busy and the second probe will fail.

To fix this, just drop the faulty check and instead verify that the
port number is valid (ie. in the possible range).

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 drivers/phy/marvell/phy-mvebu-cp110-comphy.c | 2 --
 1 file changed, 2 deletions(-)

diff --git a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
index 31b9a1c18345..6cae6227c7f8 100644
--- a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
+++ b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c

@@ -567,8 +567,6 @@ static struct phy *mvebu_comphy_xlate(struct device *dev,
 		return phy;
 
 	lane = phy_get_drvdata(phy);
-	if (lane->port >= 0)
-		return ERR_PTR(-EBUSY);
 	lane->port = args->args[0];
 
 	return phy;

-- 
2.19.1