Uwe Kleine-König [off-list ref] wrote:

Hello Thierry,

On Thu, Nov 15, 2018 at 04:25:45PM +0100, Thierry Reding wrote:

quoted

On Wed, Nov 14, 2018 at 10:51:20PM +0100, Uwe Kleine-König wrote:  

quoted

On Wed, Nov 14, 2018 at 12:34:49PM +0100, Thierry Reding wrote:  

[...]

quoted

quoted

Also dts writes don't need to lookup the needed GPIO numbers and pinctrl.  

Just to clarify: I don't think that we need to get the GPIO number
involved in this case, because we don't have to reconfigure the pin as
GPIO to make this work. The only reason that Michal's proposal did that
is because that was believed to be necessary. But if the pin can just be
configured with a 100k pull-up, that's enough to pull the pin high when
we need it.  

Unless the gpio happens to be configured as output at the wrong value.
Further I'm not sure if the pwm in disabled state actively pulls to 0
and if in this state the PU of the pin is good enough to ensure a one
here. That would need verification first.

No. You can disable the output driver via pinctrl, so that only the
selected pull-up/down is relevant. The pin function and GPIO register
settings don't matter at all in this case.


Lothar Waßmann
-- 
___________________________________________________________

Ka-Ro electronics GmbH | Pascalstraße 22 | D - 52076 Aachen
Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10
Geschäftsführer: Matthias Kaussen
Handelsregistereintrag: Amtsgericht Aachen, HRB 4996

www.karo-electronics.de | info@karo-electronics.de
___________________________________________________________