[PATCH v3 2/3] dt-bindings: net: dsa: Document B53 SRAB interrupts and registers
From: Florian Fainelli <f.fainelli@gmail.com>
Date: 2018-08-31 19:20:58
Also in:
linux-arm-kernel, lkml
Subsystem:
networking drivers, networking [dsa], open firmware and flattened device tree bindings, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Vladimir Oltean, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document the Broadcom roboswitch Switch Register Access Block interrupt lines and additional register base addresses for port mux configuration and SGMII status/configuration registers. Signed-off-by: Florian Fainelli <f.fainelli@gmail.com> --- .../devicetree/bindings/net/dsa/b53.txt | 36 +++++++++++++++++++ 1 file changed, 36 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/dsa/b53.txt b/Documentation/devicetree/bindings/net/dsa/b53.txt
index 1811e1972a7a..5201bc15fdd6 100644
--- a/Documentation/devicetree/bindings/net/dsa/b53.txt
+++ b/Documentation/devicetree/bindings/net/dsa/b53.txt@@ -46,6 +46,42 @@ Required properties: "brcm,bcm6328-switch" "brcm,bcm6368-switch" and the mandatory "brcm,bcm63xx-switch" +Required properties for BCM585xx/586xx/88312 SoCs: + + - reg: a total of 3 register base addresses, the first one must be the + Switch Register Access block base, the second is the port 5/4 mux + configuration register and the third one is the SGMII configuration + and status register base address. + + - interrupts: a total of 13 interrupts must be specified, in the following + order: port 0-5, 7-8 link status change, then the integrated PHY interrupt, + then the timestamping interrupt and the sleep timer interrupts for ports + 5,7,8. + +Optional properties for BCM585xx/586xx/88312 SoCs: + + - reg-names: a total of 3 names matching the 3 base register address, must + be in the following order: + "srab" + "mux_config" + "sgmii_config" + + - interrupt-names: a total of 13 names matching the 13 interrupts specified + must be in the following order: + "link_state_p0" + "link_state_p1" + "link_state_p2" + "link_state_p3" + "link_state_p4" + "link_state_p5" + "link_state_p7" + "link_state_p8" + "phy" + "ts" + "imp_sleep_timer_p5" + "imp_sleep_timer_p7" + "imp_sleep_timer_p8" + See Documentation/devicetree/bindings/net/dsa/dsa.txt for a list of additional required and optional properties.
--
2.17.1