[PATCH v5 4/7] dt-bindings: i2c: designware: document MSCC Ocelot bindings
From: Alexandre Belloni <alexandre.belloni@bootlin.com>
Date: 2018-08-31 15:11:58
Also in:
linux-i2c, linux-mips, lkml
Subsystem:
i2c subsystem host drivers, open firmware and flattened device tree bindings, the rest · Maintainers:
Andi Shyti, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document bindings for the Microsemi Ocelot integration of the Designware I2C controller. Reviewed-by: Rob Herring <robh@kernel.org> Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com> --- Documentation/devicetree/bindings/i2c/i2c-designware.txt | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/i2c/i2c-designware.txt b/Documentation/devicetree/bindings/i2c/i2c-designware.txt
index fbb0a6d8b964..3e4bcc2fb6f7 100644
--- a/Documentation/devicetree/bindings/i2c/i2c-designware.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c-designware.txt@@ -3,6 +3,7 @@ Required properties : - compatible : should be "snps,designware-i2c" + or "mscc,ocelot-i2c" with "snps,designware-i2c" for fallback - reg : Offset and length of the register set for the device - interrupts : <IRQ> where IRQ is the interrupt number.
@@ -11,8 +12,12 @@ Recommended properties : - clock-frequency : desired I2C bus clock frequency in Hz. Optional properties : + - reg : for "mscc,ocelot-i2c", a second register set to configure the SDA hold + time, named ICPU_CFG:TWI_DELAY in the datasheet. + - i2c-sda-hold-time-ns : should contain the SDA hold time in nanoseconds. - This option is only supported in hardware blocks version 1.11a or newer. + This option is only supported in hardware blocks version 1.11a or newer and + on Microsemi SoCs ("mscc,ocelot-i2c" compatible). - i2c-scl-falling-time-ns : should contain the SCL falling time in nanoseconds. This value which is by default 300ns is used to compute the tLOW period.
--
2.19.0.rc1