[PATCH v2 02/40] dt-bindings: mmc: tegra: Add pad voltage control properties
From: Aapo Vienamo <hidden>
Date: 2018-08-10 18:08:58
Also in:
linux-mmc, linux-tegra, lkml
Subsystem:
multimedia card (mmc), secure digital (sd) and sdio subsystem, open firmware and flattened device tree bindings, the rest · Maintainers:
Ulf Hansson, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document the pinctrl bindings used by the SDHCI driver to reconfigure pad voltages on controllers supporting multiple voltage levels. Signed-off-by: Aapo Vienamo <redacted> Reviewed-by: Mikko Perttunen <mperttunen@nvidia.com> Reviewed-by: Rob Herring <robh@kernel.org> --- .../bindings/mmc/nvidia,tegra20-sdhci.txt | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+)
diff --git a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
index 9bce578..90c214d 100644
--- a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
+++ b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt@@ -38,3 +38,25 @@ sdhci@c8000200 { power-gpios = <&gpio 155 0>; /* gpio PT3 */ bus-width = <8>; }; + +Optional properties for Tegra210 and Tegra186: +- pinctrl-names, pinctrl-0, pinctrl-1 : Specify pad voltage + configurations. Valid pinctrl-names are "sdmmc-3v3" and "sdmmc-1v8" + for controllers supporting multiple voltage levels. The order of names + should correspond to the pin configuration states in pinctrl-0 and + pinctrl-1. + +Example: +sdhci@700b0000 { + compatible = "nvidia,tegra210-sdhci", "nvidia,tegra124-sdhci"; + reg = <0x0 0x700b0000 0x0 0x200>; + interrupts = <GIC_SPI 14 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&tegra_car TEGRA210_CLK_SDMMC1>; + clock-names = "sdhci"; + resets = <&tegra_car 14>; + reset-names = "sdhci"; + pinctrl-names = "sdmmc-3v3", "sdmmc-1v8"; + pinctrl-0 = <&sdmmc1_3v3>; + pinctrl-1 = <&sdmmc1_1v8>; + status = "disabled"; +};
--
2.7.4