On Fri, Jul 20, 2018 at 1:16 PM Jon Hunter [off-list ref] wrote:

Adding Linus ...

OMG this sounds bad.

quoted

quoted

I don't know offhand. Doesn't look like it if you have custom values.

It's listed under "Supported generic properties" in
pinctrl-bindings.txt. The convention seems to be not to add a vendor
prefix even though such custom macro values are used. The property is
currently used by qcom,pmic-gpio, qcom,pmic-mpp, and renesas,pfc-pinctrl.
I could not find a bindings document describing it with a vendor prefix.

Looking at other users of the 'power-source' property it is not clear to
me if the values should/can be vendor specific or not. I see cases where
some people use definitions and others use actual voltages.

Linus, any recommendations here?

It's a bit of imperfect world here.

I always imagines it was some kind of enumerator
like source A, B or C... so 0, 1 defined in sime include/dt-bindings/*
would make most sense to me.

In general, use SI-units if you can, else use something that makes
sense for the people writing the device tree. These enumerators
seems to make sense.

If nothing makes any sense, maybe a custom property makes it
make sense.

Yours,
Linus Walleij