[PATCH] dt-bindings: thermal: qcom-spmi-temp-alarm: Fix documentation of 'reg'
From: Matthias Kaehlcke <mka@chromium.org>
Date: 2018-07-24 23:51:40
Also in:
linux-pm, lkml
Subsystem:
arm/qualcomm mailing list, open firmware and flattened device tree bindings, the rest, thermal · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds, Rafael J. Wysocki, Daniel Lezcano
The documentation claims that the 'reg' property consists of two values, the SPMI address and the length of the controller's registers. However the SPMI bus to which it is added specifies "#size-cells = <0>;". Remove the controller register length from the documentation of the field and the example. Signed-off-by: Matthias Kaehlcke <mka@chromium.org> --- .../devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
index 290ec06fa33a..86fb41fe772f 100644
--- a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
+++ b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt@@ -6,8 +6,7 @@ interrupt signal and status register to identify high PMIC die temperature. Required properties: - compatible: Should contain "qcom,spmi-temp-alarm". -- reg: Specifies the SPMI address and length of the controller's - registers. +- reg: Specifies the SPMI address. - interrupts: PMIC temperature alarm interrupt. - #thermal-sensor-cells: Should be 0. See thermal.txt for a description.
@@ -20,7 +19,7 @@ Example: pm8941_temp: thermal-alarm@2400 { compatible = "qcom,spmi-temp-alarm"; - reg = <0x2400 0x100>; + reg = <0x2400>; interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>; #thermal-sensor-cells = <0>;
--
2.18.0.233.g985f88cf7e-goog