On Wed, 18 Jul 2018 12:55:14 +0300
Sakari Ailus [off-list ref] wrote:

Hi Yong,

On Thu, Jul 05, 2018 at 03:48:02PM +0800, Yong wrote:

quoted

quoted

quoted

+
+/* -----------------------------------------------------------------------------
+ * Media Operations
+ */
+static int sun6i_video_formats_init(struct sun6i_video *video,
+				    const struct media_pad *remote)
+{
+	struct v4l2_subdev_mbus_code_enum mbus_code = { 0 };
+	struct sun6i_csi *csi = video->csi;
+	struct v4l2_format format;
+	struct v4l2_subdev *subdev;
+	u32 pad;
+	const u32 *pixformats;
+	int pixformat_count = 0;
+	u32 subdev_codes[32]; /* subdev format codes, 32 should be enough */
+	int codes_count = 0;
+	int num_fmts = 0;
+	int i, j;
+
+	pad = remote->index;
+	subdev = media_entity_to_v4l2_subdev(remote->entity);
+	if (subdev == NULL)
+		return -ENXIO;
+
+	/* Get supported pixformats of CSI */
+	pixformat_count = sun6i_csi_get_supported_pixformats(csi, &pixformats);
+	if (pixformat_count <= 0)
+		return -ENXIO;
+
+	/* Get subdev formats codes */
+	mbus_code.pad = pad;
+	mbus_code.which = V4L2_SUBDEV_FORMAT_ACTIVE;
+	while (!v4l2_subdev_call(subdev, pad, enum_mbus_code, NULL,
+				 &mbus_code)) {

The formats supported by the external sub-device may depend on horizontal
and vertical flipping. You shouldn't assume any particular configuration
here: instead, bridge drivers generally just need to make sure the formats
match in link validation when streaming is started. At least the CSI-2
receiver driver and the DMA engine driver (video device) should check the
configuration is valid. See e.g. the IPU3 driver:
drivers/media/pci/intel/ipu3/ipu3-cio2.c .

Can mbus_code be added dynamically ?
The code here only enum the mbus code and get the possible supported
pairs of pixformat and mbus by SoC. Not try to check if the formats
(width height ...) is valid or not. The formats validation will be 
in link validation when streaming is started as per your advise. 

The formats that can be enumerated from the sensor here are those settable
using SUBDEV_S_FMT. The enumeration will change on raw sensors if you use
the flipping controls. As the bridge driver implements MC as well as subdev
APIs, generally the sensor configuration is out of scope of this driver
since it's directly configured from the user space.

Just check that the pipeline is valid before starting streaming in your
driver.

OK. I will take some time to change these code.

-- 
Kind regards,

Sakari Ailus
sakari.ailus-VuQAYsv1563Yd54FQh9/CA@public.gmane.org

Thanks,
Yong