On Mon, May 21, 2018 at 01:31:30PM +0300, Ilia Lin wrote:

+#define SILVER_LEAD	0
+#define GOLD_LEAD	2

Okay, two different values here, but "GOLD_LEAD" appears unused.

+	cpu_dev_silver = get_cpu_device(SILVER_LEAD);
+	if (NULL == cpu_dev_silver)
+		return -ENODEV;
+
+	cpu_dev_gold = get_cpu_device(SILVER_LEAD);
+	if (NULL == cpu_dev_gold)
+		return -ENODEV;

get_cpu_device() takes the logical CPU number.  So the above gets CPU 0
each time, and so cpu_dev_silver == cpu_dev_gold here.  So what's the
point of the second get_cpu_device() ?  If it's supposed to be:

	cpu_dev_gold = get_cpu_device(GOLD_LEAD);

That would get CPU 2, but in terms of these defines, it doesn't make that
much sense.  What exactly does "silver lead" and "gold lead" refer to in
these definitions?

+	opp_silver = dev_pm_opp_set_supported_hw(cpu_dev_silver,&versions,1);
+	if (IS_ERR(opp_silver)) {
+		dev_err(cpu_dev_silver, "Failed to set supported hardware\n");
+		ret = PTR_ERR(opp_silver);
+		goto free_np;
+	}
+
+	opp_gold = dev_pm_opp_set_supported_hw(cpu_dev_gold,&versions,1);
+	if (IS_ERR(opp_gold)) {
+		dev_err(cpu_dev_gold, "Failed to set supported hardware\n");
+		ret = PTR_ERR(opp_gold);
+		goto free_opp_silver;
+	}

Given that cpu_dev_silver == cpu_dev_gold, doesn't the second call to
dev_pm_opp_set_supported_hw() always fail, as opp_table->supported_hw
will be set by the first call?

To me, this driver looks completely useless as it will always fail to
initialise, and I question whether this code has even been runtime
tested.

-- 
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up
According to speedtest.net: 8.21Mbps down 510kbps up