[PATCH v4 2/4] dt-bindings: at24: fix formatting and style
From: Bartosz Golaszewski <hidden>
Date: 2017-12-28 10:49:56
Also in:
linux-i2c, lkml
Subsystem:
open firmware and flattened device tree bindings, the rest · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Make formatting and style consistent for the entire document. This patch doesn't change the content of the binding. Signed-off-by: Bartosz Golaszewski <redacted> Reviewed-by: Javier Martinez Canillas <javierm@redhat.com> --- Documentation/devicetree/bindings/eeprom/at24.txt | 22 +++++++++++----------- 1 file changed, 11 insertions(+), 11 deletions(-)
diff --git a/Documentation/devicetree/bindings/eeprom/at24.txt b/Documentation/devicetree/bindings/eeprom/at24.txt
index 0c8e1341908f..5e0dfd25b1e3 100644
--- a/Documentation/devicetree/bindings/eeprom/at24.txt
+++ b/Documentation/devicetree/bindings/eeprom/at24.txt@@ -39,23 +39,23 @@ Required properties: "renesas,r1ex24002" - the fallback is "atmel,24c02" - - reg : the I2C address of the EEPROM + - reg: The I2C address of the EEPROM. Optional properties: - - pagesize : the length of the pagesize for writing. Please consult the - manual of your device, that value varies a lot. A wrong value - may result in data loss! If not specified, a safety value of - '1' is used which will be very slow. + - pagesize: The length of the pagesize for writing. Please consult the + manual of your device, that value varies a lot. A wrong value + may result in data loss! If not specified, a safety value of + '1' is used which will be very slow. - - read-only: this parameterless property disables writes to the eeprom + - read-only: This parameterless property disables writes to the eeprom. - - size: total eeprom size in bytes + - size: Total eeprom size in bytes. - - no-read-rollover: - This parameterless property indicates that the multi-address - eeprom does not automatically roll over reads to the next - slave address. Please consult the manual of your device. + - no-read-rollover: This parameterless property indicates that the + multi-address eeprom does not automatically roll over + reads to the next slave address. Please consult the + manual of your device. - wp-gpios: GPIO to which the write-protect pin of the chip is connected.
--
2.15.1