[PATCH 1/2] dt-binding: can: mcp2517fd: document device tree bindings

@@ -0,0 +1,47 @@
+* Microchip MCP2517 stand-alone CAN controller device tree bindings
+
+Required properties:
+ - compatible: Should be one of the following:
+   - "microchip,mcp2517fd" for MCP2517fd.
+ - reg: SPI chip select.
+ - clocks: The clock feeding the CAN controller.
+ - interrupt-parent: The parent interrupt controller.
+ - interrupts: Should contain IRQ line for the CAN controller.
+
+Optional properties:
+ - vdd-supply: Regulator that powers the CAN controller.
+ - xceiver-supply: Regulator that powers the CAN transceiver.
+ - microchip,clock_out_div = <0|1|2|4|10>: Clock output pin divider
+					   0 = Start of Frame output
+					   default: 10
+ - microchip,clock_div = <1|2>: internal clock divider - default 1
+ - microchip,gpio_opendrain: gpio (int0,1) in open drain mode
+			     instead of default push/pull
+ - microchip,int_opendrain: int pin in open drain mode
+			    instead of default push/pull
+ - microchip,txcan_opendrain: txcan pin in open drain mode
+			      instead of default push/pull
+ - microchip,gpio0_mode : gpio mode functionality
+			  0 = input
+			  1 = TX interrupt output - default
+			  2 = output default low
+			  3 = output default high
+			  4 = (tx) transceiver standby
+ - microchip,gpio1_mode : gpio mode functionality
+			  0 = input - default
+			  1 = RX interrupt output - default
+			  2 = output default low
+			  3 = output default high
+
+Example:
+	can0: can@1 {
+		compatible = "microchip,mcp2515";
+		reg = <1>;
+		clocks = <&clk24m>;
+		interrupt-parent = <&gpio4>;
+		interrupts = <13 0x8>;
+		vdd-supply = <&reg5v0>;
+		xceiver-supply = <&reg5v0>;
+		microchip,gpio0_mode = <4>;
+		microchip,gpio0_mode = <1>;
+	};