quoted hunk ↗ jump to hunk
+#define DWMAC_sUN8I_MDIO_MUX_INTERNAL_ID 0
+#define DWMAC_sUN8I_MDIO_MUX_EXTERNAL_ID 1
/* H3/A64 specific bits */
#define SYSCON_RMII_EN BIT(13) /* 1: enable RMII (overrides EPIT) */
@@ -634,6 +639,76 @@ static int sun8i_dwmac_reset(struct stmmac_priv *priv)
return 0;
}
+/* MDIO multiplexing switch function
+ * This function is called by the mdio-mux layer when it thinks the mdio bus
+ * multiplexer needs to switch.
+ * 'current_child' is the current value of the mux register
+ * 'desired_child' is the value of the 'reg' property of the target child MDIO
+ * node.
+ * The first time this function is called, current_child == -1.
+ * If current_child == desired_child, then the mux is already set to the
+ * correct bus.
+ *
+ * Note that we do not use reg/mask like mdio-mux-mmioreg because we need to
+ * know easily which bus is used (reset must be done only for desired bus).
+ */
+static int mdio_mux_syscon_switch_fn(int current_child, int desired_child,
+ void *data)
+{
+ struct stmmac_priv *priv = data;
+ struct sunxi_priv_data *gmac = priv->plat->bsp_priv;
+ u32 reg, val;
+ int ret = 0;
+ bool need_reset = false;
+
+ if (current_child ^ desired_child) {
+ regmap_read(gmac->regmap, SYSCON_EMAC_REG, ®);
+ switch (desired_child) {
+ case DWMAC_sUN8I_MDIO_MUX_INTERNAL_ID:
+ dev_info(priv->device, "Switch mux to internal PHY");
+ val = (reg & ~H3_EPHY_MUX_MASK) | H3_EPHY_SELECT;
+ if (gmac->use_internal_phy)
+ need_reset = true;
+ break;
This i don't get. Why do you need use_internal_phy? Isn't that
implicit from DWMAC_sUN8I_MDIO_MUX_INTERNAL_ID? Is it even possible to
use an external PHY on the internal MDIO bus?
quoted hunk ↗ jump to hunk
+ case DWMAC_sUN8I_MDIO_MUX_EXTERNAL_ID:
+ dev_info(priv->device, "Switch mux to external PHY");
+ val = (reg & ~H3_EPHY_MUX_MASK) | H3_EPHY_SHUTDOWN;
+ if (!gmac->use_internal_phy)
+ need_reset = true;
+ break;
And is it possible to use the internal PHY on the external bus?
Andrew