Enables the ADV7180 decoder sensor. The ADV7180 connects to the
parallel-bus mux input on ipu1_csi0_mux.

The ADV7180 power pin is via max7310_b port expander.

Signed-off-by: Steve Longerbeam <redacted>

- Use IRQ_TYPE_LEVEL_LOW instead of 0x8 for interrupt type for clarity.
- For 8-bit parallel IPU1-CSI0 bus connection only data[12-19] are used.

Signed-off-by: Tim Harvey <tharvey-UMMOYl/HMS+akBO8gow8eQ@public.gmane.org>
---
 arch/arm/boot/dts/imx6qdl-sabreauto.dtsi | 50 ++++++++++++++++++++++++++++++++
 1 file changed, 50 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
index 1212f82..c24af28 100644
--- a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi

@@ -124,6 +124,21 @@
                        #size-cells = <0>;
                        reg = <1>;

+                       adv7180: camera@21 {
+                               compatible = "adi,adv7180";
+                               reg = <0x21>;
+                               powerdown-gpios = <&max7310_b 2 GPIO_ACTIVE_LOW>;
+                               interrupt-parent = <&gpio1>;
+                               interrupts = <27 IRQ_TYPE_LEVEL_LOW>;
+
+                               port {
+                                       adv7180_to_ipu1_csi0_mux: endpoint {
+                                               remote-endpoint = <&ipu1_csi0_mux_from_parallel_sensor>;
+                                               bus-width = <8>;
+                                       };
+                               };
+                       };
+
                        max7310_a: gpio@30 {
                                compatible = "maxim,max7310";
                                reg = <0x30>;

@@ -151,6 +166,25 @@
        };
 };

+&ipu1_csi0_from_ipu1_csi0_mux {
+       bus-width = <8>;
+};
+
+&ipu1_csi0_mux_from_parallel_sensor {
+       remote-endpoint = <&adv7180_to_ipu1_csi0_mux>;
+       bus-width = <8>;
+};
+
+&ipu1_csi0 {
+       pinctrl-names = "default";
+       pinctrl-0 = <&pinctrl_ipu1_csi0>;
+
+       /* enable frame interval monitor on this port */
+       fim {
+               status = "okay";
+       };