On Tue, Jun 6, 2017 at 7:38 AM, Florian Fainelli [off-list ref] wrote:

On 06/05/2017 09:51 AM, Florian Fainelli wrote:

quoted

On 06/01/2017 11:34 PM, Anup Patel wrote:

quoted

This patchset adds initial support of Broadcom Stingray SOC
by reusing existing Broadcom iProc device drivers.

Most of the patches in this patchset are DT patches except
the Stingray clock tree support which just one patch.

This patchset is based on Linux-4.12-rc3 and it is also available
at stingray-v6 branch of https://github.com/Broadcom/arm64-linux.git

Changes since v5:
 - Rebased patches for Linux-4.12-rc3
 - Update DT node names to match register offset

Changes since v4:
 - Reduce number of include headers in Stingray clk driver

Changes since v3:
 - Rebased patches for Linux-4.12-rc1
 - Updated PATCH3 to have all clocks except genpll3 to be
   registered via platform driver probe

Changes since v2:
 - Remove default bootargs from chosen DT node
 - Remove "linux" prefix from stdout DT attribute of chosen DT node
 - Remove use of GIC_CPU_MASK_xxx() for PPIs

Changes since v1:
 - Rebased patches for Linux-4.12-rc1
 - Removed unwanted /memreserve/ from bcm958742-base.dtsi
 - Use ranges DT property to clear view of memory-layout
 - Make bcm-sr.h part of clock DT bindings patch

Anup Patel (3):
  dt-bindings: bcm: Add Broadcom Stingray bindings document
  arm64: dts: Initial DTS files for Broadcom Stingray SOC
  arm64: dts: Add PL022, PL330 and SP805 DT nodes for Stingray

Oza Pawandeep (1):
  arm64: dts: Add I2C DT nodes for Stingray SoC

Pramod Kumar (3):
  arm64: dts: Add NAND DT nodes for Stingray SOC
  arm64: dts: Add pinctrl DT nodes for Stingray SOC
  arm64: dts: Add GPIO DT nodes for Stingray SOC

Sandeep Tripathy (3):
  dt-bindings: clk: Extend binding doc for Stingray SOC
  clk: bcm: Add clocks for Stingray SOC
  arm64: dts: Add clock DT nodes for Stingray SOC

Srinath Mannam (1):
  arm64: dts: Add PWM and SDHCI DT nodes for Stingray SOC

Applied patches 1, 4-11 to devicetree-arm64/next, thanks!

Also took patch 2, to make sure everything builds properly, Stephen, let
me know if you want me to take patch #3 as well.

Thanks for patches 1-2 and patches 4-11.

Regarding PATCH3, please give us one day. We recently had
minor comments from Stephen which we will address and
send v7 of PATCH3.

Regards,,
Anup