Re: [PATCH] dt-bindings: power: New bindings for ltc3651-charger
From: Rob Herring <robh@kernel.org>
Date: 2017-05-08 17:12:10
Also in:
linux-pm, lkml
On Fri, May 05, 2017 at 08:38:35AM +0200, Mike Looijmans wrote:
quoted hunk ↗ jump to hunk
This adds the devicetree bindings documentation for the LTC3651 battery charger. Signed-off-by: Mike Looijmans <redacted> --- .../bindings/power/supply/ltc3651-charger.txt | 26 ++++++++++++++++++++++ 1 file changed, 26 insertions(+) create mode 100644 Documentation/devicetree/bindings/power/supply/ltc3651-charger.txtdiff --git a/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt new file mode 100644 index 0000000..a7dd80f --- /dev/null +++ b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt@@ -0,0 +1,26 @@ +ltc3651-charger + +Required properties: + - compatible: "lltc,ltc3651-charger" + - acpr-gpios: Connect to ACPR output. See remark below. + +Optional properties: + - fault-gpios: Connect to FAULT output. See remark below. + - chrg-gpios: Connect to CHRG output. See remark below.
All the gpios need vendor prefix.
+ +The ltc3651 outputs are open-drain type and active low. The driver assumes the +GPIO reports "active" when the output is asserted, so if the pins have been +connected directly, the GPIO flags should be set to active low also. + +The driver will attempt to aquire interrupts for all GPIOs. If the system is +not capabale of providing that, the driver cannot report changes and userspace +will need to periodically read the sysfs attributes to detect changes.
If these are interrupts, then you should use the interrupt binding instead (most GPIO controllers are also interrupt controllers).
+
+Example:
+
+ charger: battery-charger {
+ compatible = "lltc,ltc3651-charger";
+ acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
+ fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
+ chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
+ };
--
1.9.1