Re: [PATCH v7 3/3] Bluetooth: btusb: Configure Marvell to use one of the pins for oob wakeup

Hi,

The Marvell devices may have many gpio pins, and hence for wakeup
on these out-of-band pins, the chip needs to be told which pin is
to be used for wakeup, using an hci command.

Thus, we read the pin number etc from the device tree node and send
a command to the chip.

Signed-off-by: Rajat Jain <redacted>
Reviewed-by: Brian Norris <redacted>
Acked-by: Rob Herring <redacted>
---
v7: Same as v6
v6: same as v5
v5: same as v5
v4: same as v3
v3: * remove the Marvell specific id table and check
   * Add reference to marvell-bt-8xxx.txt in btusb.txt
   * Add "Reviewed-by" and "Acked-by"    
v2: Fix the binding document to specify to use "wakeup" interrupt-name

Documentation/devicetree/bindings/net/btusb.txt    |  3 ++
.../{marvell-bt-sd8xxx.txt => marvell-bt-8xxx.txt} | 46 +++++++++++++++----
drivers/bluetooth/btusb.c                          | 51 ++++++++++++++++++++++
3 files changed, 92 insertions(+), 8 deletions(-)
rename Documentation/devicetree/bindings/net/{marvell-bt-sd8xxx.txt => marvell-bt-8xxx.txt} (50%)

all 3 patches have been applied to bluetooth-next tree.

Regards

Marcel

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html