From: Steve Twiss <redacted>

Device tree binding information for DA9062 and DA9061 thermal junction
temperature monitor.

Binding descriptions for the DA9061 and DA9062 thermal TJUNC supervisor
device driver, using a single THERMAL_TRIP_HOT trip-wire and allowing for
a configurable polling period for over-temperature polling.

Signed-off-by: Steve Twiss <redacted>

---
This patch applies against linux-next and v4.8

v1 -> v2
 - Patch renamed from [PATCH V1 08/10] to [PATCH V2 03/10] -- these
   changes were made to fix checkpatch warnings caused by the patch
   set dependency order
 - A second example for DA9061 is provided to highlight the use of a
   fall-back compatible option for the DA9062 watchdog driver

Hi,

This patch depends on acceptance of the main code for the thermal device
driver:
  [PATCH V2 09/10] thermal: da9061: TJUNC temperature driver 

The previous [PATCH V1 08/10] was acked-by: Rob Herring, however this has
not been added because changes have been made to add a new binding
example. This describes the use of DA9061.
This addition was made after alterations to the device driver meant that a
fall-back compatible string could reuse the DA9062 device driver.
 
Regards,
Steve Twiss, Dialog Semiconductor Ltd.


 .../devicetree/bindings/thermal/da9062-thermal.txt | 37 ++++++++++++++++++++++
 1 file changed, 37 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/thermal/da9062-thermal.txt

diff --git a/Documentation/devicetree/bindings/thermal/da9062-thermal.txt b/Documentation/devicetree/bindings/thermal/da9062-thermal.txt
new file mode 100644
index 0000000..fb207ff
--- /dev/null
+++ b/Documentation/devicetree/bindings/thermal/da9062-thermal.txt

@@ -0,0 +1,37 @@
+* Dialog DA9062/61 TJUNC Thermal Module
+
+This module is part of the DA9061/DA9062. For more details about entire
+DA9062 and DA9061 chips see Documentation/devicetree/bindings/mfd/da9062.txt
+
+Junction temperature thermal module uses an interrupt signal to identify
+high THERMAL_TRIP_HOT temperatures for the PMIC device.
+
+Required properties:
+
+- compatible: should be one of:
+        dlg,da9061-thermal
+        dlg,da9062-thermal
+
+Optional properties:
+
+- dlg,tjunc-temp-polling-period-ms : Specify the polling period, measured
+    in milliseconds, between thermal zone device update checks.