On Fri, Nov 04, 2016 at 04:31:40PM +0300, Sergei Shtylyov wrote:

Hello.

On 11/4/2016 8:11 AM, Jon Mason wrote:

quoted

Add support for the AMAC ethernet to the Broadcom Northstar2 SoC device
tree

Signed-off-by: Jon Mason <redacted>
---
arch/arm64/boot/dts/broadcom/ns2-svk.dts |  5 +++++
arch/arm64/boot/dts/broadcom/ns2.dtsi    | 12 ++++++++++++
2 files changed, 17 insertions(+)

diff --git a/arch/arm64/boot/dts/broadcom/ns2-svk.dts b/arch/arm64/boot/dts/broadcom/ns2-svk.dts
index b09f3bc..c4d5442 100644
--- a/arch/arm64/boot/dts/broadcom/ns2-svk.dts
+++ b/arch/arm64/boot/dts/broadcom/ns2-svk.dts

@@ -56,6 +56,10 @@

	};
};

+&enet {
+	status = "ok";

   The spec dictates it should be "okay" (although "ok" is also recognized).

The rest of the file uses "ok".  So, the addition above is consistent
with the other entries.

Perhaps a patch outside this series to convert the entire file from
"ok" to "okay" would be acceptable to you.

Thanks,
Jon

quoted

+};
+
&pci_phy0 {
	status = "ok";
};

@@ -174,6 +178,7 @@

&mdio_mux_iproc {
	mdio@10 {
		gphy0: eth-phy@10 {
+			enet-phy-lane-swap;
			reg = <0x10>;
		};
	};

[...]

MBR, Sergei