On Wed 26 Oct 16:32 PDT 2016, Michael Scott wrote:

Initial pinctrl driver for QCOM msm8994 platforms.

In order to continue the initial board support for QCOM msm8994/msm8992
presented in patches from Jeremy McNicoll [off-list ref], let's put
a proper pinctrl driver in place.

Currently, the DT for these platforms uses the msm8x74 pinctrl driver to enable
basic UART.  Beyond the first few pins the rest are different enough to justify
it's own driver.

Note: This driver is also be used by QCOM's msm8992 platform as it's TLM block
is the same.

I'm not up to speed on the 8992/8994 story, but please add a
"qcom,msm8992-pinctrl" compatible to the list as well.

- Initial formatting and style was taken from the msm8x74 pinctrl driver added
  by Björn Andersson [off-list ref]
- Data was then adjusted per QCOM MSM8994 documentation for Top Level Multiplexing

I think this is good enough. It looks reasonable and you based it on the
data sheet. Any fixes to the tables can be added incrementally.

- Bindings documentation was based on qcom,msm8996-pinctrl.txt by
  Joonwoo Park [off-list ref] and then modified for msm8994 content

Signed-off-by: Michael Scott <redacted>

Please add the compatible and you have my

Acked-by: Bjorn Andersson <redacted>

Regards,
Bjorn