Re: [PATCH] iio: sx9500: add final devicetree support

On Fri, 2016-09-02 at 12:12 -0300, Fabio Estevam wrote:

On Fri, Sep 2, 2016 at 12:04 PM, Christoph Fritz
[off-list ref] wrote:

quoted

Here on my board I'm using the reset pin as an open-drain with external
pullup, so GPIO_ACTIVE_HIGH is valid.

As this is an example, I don't care if it says _HIGH or _LOW.

Then probably it is better to remove "reset-gpios" from the example.

The driver does not parse this dt property and the reset is being done
via software command as far as I can see.

What do you mean by "software command", to send a reset command by i2c?

The reset GPIO is fetched in sx9500 here:

See sx9500_gpio_probe():
...
        data->gpiod_rst = devm_gpiod_get_index(dev, SX9500_GPIO_RESET,
                                               0, GPIOD_OUT_HIGH);
...