Re: [PATCHv2 0/2] net: fec: Reset ethernet PHY whenever the enet_out clock is being enabled

Hi all,

On Tue, 2016-01-12 at 21:30 +0100, Uwe Kleine-König wrote:

Hello,

On Tue, Jan 12, 2016 at 05:04:44PM +0100, Lothar Waßmann wrote:

quoted

quoted

On Tue, Jan 12, 2016 at 04:17:54PM +0100, Lothar Waßmann wrote:

quoted

This patchset fixes a regression introduced by
commit e8fcfcd5684a ("net: fec: optimize the clock management
to save power")
for ethernet PHYs that are using ENET_OUT as reference clock
(on i.MX6 or i.MX28)

Changes vs. v1:
- fixed reference to the commit that introduced the regression.
- dropped patch to use gpiod framework. This should be added
later,
  after the affected DTBs have been updated to specify the
correct
  gpio_flags.

Patch overview:
1. cleanup patch to remove redundant NULL checks
2. call fec_reset_phy() after the ENET_OUT clock has been
enabled

I definitely want to test these on my SolidRun boards before
these get
merged: the AR8035 on there is configured via pin-straps, and
then
further tweaked with PHY quirks.  Resetting with the iMX6 in the
wrong state may result in the AR8035 being reconfigured (even
jumping
to a different MDIO address) and certainly would need the PHY
quirks
re-running.

As far as I can tell, all SolidRun boards do not specify the
enet_out
clock in the dtb, so the PHY reset behaviour should be unaffected
by
this patch on those boards, since the additional fec_reset_phy()
call is
framed by:
if (fep->clk_enet_out) {
	...
}

But verifying this explicitly is of course a good idea.

If the SolidRun boards don't do this, this doesn't mean it's safe in
general. The problem is real, isn't it?

Anything new on this topic? I am facing the same issue with Linux
Kernel 4.7 and the MCSC LAN8720A on an i.MX28 board.

I found this patch on patchwork and it works for me.

Best regard
Jörg Krause

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel