Re: [PATCH V2 RFC 0/6] ARM: dts: bcm2835: Add Raspberry Pi Zero

Stefan Wahren [off-list ref] writes:

Hi Eric,

quoted

Eric Anholt [off-list ref] hat am 18. August 2016 um 20:14 geschrieben:


Stefan Wahren [off-list ref] writes:

quoted

This patch series is only a draft and not intended to be merged. Patches 1
and 2
aren't bcm2835 specific and should be helpful for other platforms. 
The patches 2 - 4 are required for otg / gadget mode. The last patch
based on the work of Lubomir Rintel [1] and Noralf Trønnes [2].

Changes since V1:
- rebase to current linux-next
- add patches 1 - 4 for otg/gadget support
- add patch 5 with model compatible
- use polarity define for ACT LED

[1] -
http://lists.infradead.org/pipermail/linux-rpi-kernel/2016-February/003221.html
[2] - https://github.com/raspberrypi/linux/pull/1239/

Stefan Wahren (6):
  usb: dwc2: core: Avoid nonsense error in gadget mode
  usb: dwc2: Add DT properties to specify fifo size in host/otg mode
  ARM: dts: bcm283x: Add missing usb clock
  ARM: dts: bcm283x: Add generic USB PHY
  DT: bindings: bcm: Add Raspberry Pi Zero
  ARM: dts: bcm2835: Add Raspberry Pi Zero

Where are we at on these?  

I would like to split the series:
part 1: Raspberry Pi Zero support (only USB host mode support)
part 2: OTG / Peripheral support for BCM2835 (hope that i reach the point)

That sounds great.

quoted

I've been holding off waiting for the USB
bits to get settled.  I can grab the bindings patch, but is there
anything else we could merge while you're working on USB?

Maybe i missed something, but i didn't received any ACK from you about this
series.

In case everything is okay, you could also merge patch 3 since it's relevant to
bcm283x and not RPi Zero specific.

Didn't miss anything.  I hadn't acked yet since it looked like there
were open questions for the USB folks.