On Thu, Jul 21, 2016 at 04:03:12PM -0500, Rob Herring wrote:

On Wed, Jul 20, 2016 at 12:49:12PM -0700, Andrey Pronin wrote:

quoted

On Wed, Jul 20, 2016 at 02:03:03PM -0500, Rob Herring wrote:

quoted

On Tue, Jul 19, 2016 at 08:41:24PM -0700, Andrey Pronin wrote:

Hi Rob,

quoted

As I mentioned, there may be common properties. It doesn't seem you 
looked, so I did:

- spi-rx-delay-us  - (optional) Microsecond delay after a read transfer.
- spi-tx-delay-us  - (optional) Microsecond delay after a write transfer.

Seems to me setting one or both of these should work for you.

Yes, good catch, my fault I didn't see those.
But they are not exactly what I mean and need. I don't need delay after
each read or write transfer. What is needed is a guaranteed time
between transfers.

So, if the next transaction doesn't come withing the next X ms (or us),
we don't waste time on inserting a delays after this transaction at all.
Following the description and always inserting a delay must work well
for short microseconds-long delays. For longer milliseconds-long delays
a different strategy of checking the time when the previous transaction
was and only delaying if it was not too long ago is better.

I'd guess that the intent is the same for all. A simple delay is 
just much easier to implement. I would think implementing the more 
sophisticated algorithm would work for all users. Perhaps with some 
threshold for a simple delay.

quoted

Thus, I won't be able to re-use these properties anyways based on their
current description in bindings/spi/spi-bus.txt.

quoted

quoted

+- sleep-delay-ms: Time after the last SPI activity, after which the chip
+  may go to sleep.
+- wake-start-delay-ms: Time after initiating wake up before the chip is
+  ready to accept commands over SPI.

I also asked why these 2 can't be hard-coded in the driver?

Sorry, I just updated this patch description in v2 to indicate why they are not
hard-coded, but didn't answer explicitly. As the firmware changes, a different
revision of it can have a different time before it sleeps in its configuration,
or the time it takes it to startup may be different. Thus, there's a way to
set it here w/o changing the driver.

The firmware and DT may not be updated in sync especially if you are 
loading the firmware from the rootfs. Are you doing DT and firmware 
updates without changing the kernel?

Rob

Hi Rob,

Thanks for the feedback. I will hard-code those parameters in the
driver instead of reading from DT.

Thanks,
Andrey

------------------------------------------------------------------------------