On Mon, May 02, 2016 at 03:18:51PM +0300, Roger Quadros wrote:

+
+	if (config->otg_work)	/* custom otg_work ? */
+		INIT_WORK(&otg->work, config->otg_work);
+	else
+		INIT_WORK(&otg->work, usb_drd_work);
+
+	otg->wq = create_singlethread_workqueue("usb_otg");

Using create_freezable_workqueue like I suggested before.

+ */
+
+#ifndef __DRIVERS_USB_COMMON_USB_OTG_H
+#define __DRIVERS_USB_COMMON_USB_OTG_H
+
+/*
+ *  A-DEVICE timing constants
+ */
+
+/* Wait for VBUS Rise  */
+#define TA_WAIT_VRISE        (100)	/* a_wait_vrise: section 7.1.2
+					 * a_wait_vrise_tmr: section 7.4.5.1
+					 * TA_VBUS_RISE <= 100ms, section 4.4
+					 * Table 4-1: Electrical Characteristics
+					 * ->DC Electrical Timing
+					 */
+/* Wait for VBUS Fall  */
+#define TA_WAIT_VFALL        (1000)	/* a_wait_vfall: section 7.1.7
+					 * a_wait_vfall_tmr: section: 7.4.5.2
+					 */
+/* Wait for B-Connect */
+#define TA_WAIT_BCON         (10000)	/* a_wait_bcon: section 7.1.3
+					 * TA_WAIT_BCON: should be between 1100
+					 * and 30000 ms, section 5.5, Table 5-1
+					 */
+/* A-Idle to B-Disconnect */
+#define TA_AIDL_BDIS         (5000)	/* a_suspend min 200 ms, section 5.2.1
+					 * TA_AIDL_BDIS: section 5.5, Table 5-1
+					 */
+/* B-Idle to A-Disconnect */
+#define TA_BIDL_ADIS         (500)	/* TA_BIDL_ADIS: section 5.2.1
+					 * 500ms is used for B switch to host
+					 * for safe
+					 */
+
+/*
+ * B-device timing constants
+ */
+
+/* Data-Line Pulse Time*/
+#define TB_DATA_PLS          (10)	/* b_srp_init,continue 5~10ms
+					 * section:5.1.3
+					 */
+/* SRP Fail Time  */
+#define TB_SRP_FAIL          (6000)	/* b_srp_init,fail time 5~6s
+					 * section:5.1.6
+					 */
+/* A-SE0 to B-Reset  */
+#define TB_ASE0_BRST         (155)	/* minimum 155 ms, section:5.3.1 */
+/* SE0 Time Before SRP */
+#define TB_SE0_SRP           (1000)	/* b_idle,minimum 1s, section:5.1.2 */
+/* SSEND time before SRP */
+#define TB_SSEND_SRP         (1500)	/* minimum 1.5 sec, section:5.1.2 */
+
+#define TB_SESS_VLD          (1000)

Seems you agree to remove above definitions.

Above two headers are not needed

-- 

Best Regards,
Peter Chen