Re: [PATCH 3/6] docs: Document BCM23550 bindings
From: Rob Herring <robh@kernel.org>
Date: 2016-05-09 19:41:40
Also in:
linux-arm-kernel, linux-pm, lkml
On Thu, May 05, 2016 at 01:48:51PM -0700, Chris Brand wrote:
quoted hunk ↗ jump to hunk
Add binding document for Broadcom BCM23550 SoC. BCM23550 has a Cluster Dormant Control IP block that holds cores in an idle state. Introduce a new CPU enable method in which the CDC is accessed to bring the core online. Signed-off-by: Chris Brand <redacted> --- .../bindings/arm/bcm/brcm,bcm23550-cpu-method.txt | 36 ++++++++++++++++++++++ .../devicetree/bindings/arm/bcm/brcm,bcm23550.txt | 15 +++++++++ Documentation/devicetree/bindings/arm/cpus.txt | 1 + 3 files changed, 52 insertions(+) create mode 100644 Documentation/devicetree/bindings/arm/bcm/brcm,bcm23550-cpu-method.txt create mode 100644 Documentation/devicetree/bindings/arm/bcm/brcm,bcm23550.txtdiff --git a/Documentation/devicetree/bindings/arm/bcm/brcm,bcm23550-cpu-method.txt b/Documentation/devicetree/bindings/arm/bcm/brcm,bcm23550-cpu-method.txt new file mode 100644 index 000000000000..b1b16872bbca --- /dev/null +++ b/Documentation/devicetree/bindings/arm/bcm/brcm,bcm23550-cpu-method.txt@@ -0,0 +1,36 @@ +Broadcom Kona Family CPU Enable Method +-------------------------------------- +This binding defines the enable method used for starting secondary +CPUs in the following Broadcom SoCs: + BCM23550 + +The enable method is specified by defining the following required +properties in the "cpu" device tree node: + - enable-method = "brcm,bcm23550-cpu-method";
"-cpu-method" is a bit redundant. brcm,bc23550 is probably sufficient.
+ - secondary-boot-reg = <...>; + +The secondary-boot-reg property is a u32 value that specifies the +physical address of the register used to request the ROM holding pen +code release a secondary CPU. The value written to the register is +formed by encoding the target CPU id into the low bits of the +physical start address it should jump to.