This patch adds drm_bridge driver for parade DSI to eDP bridge chip.

Signed-off-by: Jitao Shi <redacted>
---
Changes since v9:
 - replace dev_kmalloc with devm_kmalloc in ps8640_get_modes
 - remove ps_bridge->dsi = devm_kzalloc(dev, sizeof(struct mipi_dsi_device),
					GFP_KERNEL);
 - fix wrong condition in ps8640_validate_firmware()

The following patches are needed to support dsi host through none dsi bus:

https://patchwork.kernel.org/patch/8289181/ ("drm/dsi: check for CONFIG_OF when defining")
https://patchwork.kernel.org/patch/8289051/ ("drm/dsi: Use mipi_dsi_device_register_full for DSI device")
https://patchwork.kernel.org/patch/8289081/ ("drm/dsi: Try to match non-DT DSI devices")
https://patchwork.kernel.org/patch/8289121/ ("drm/dsi: Add routine to unregister a DSI device")
https://patchwork.kernel.org/patch/8289091/ ("drm/dsi: Get DSI host by DT device node")
---
 drivers/gpu/drm/bridge/Kconfig         |   11 +
 drivers/gpu/drm/bridge/Makefile        |    1 +
 drivers/gpu/drm/bridge/parade-ps8640.c | 1057 ++++++++++++++++++++++++++++++++
 3 files changed, 1069 insertions(+)
 create mode 100644 drivers/gpu/drm/bridge/parade-ps8640.c

diff --git a/drivers/gpu/drm/bridge/Kconfig b/drivers/gpu/drm/bridge/Kconfig
index 27e2022..b4edd8c 100644
--- a/drivers/gpu/drm/bridge/Kconfig
+++ b/drivers/gpu/drm/bridge/Kconfig

@@ -40,4 +40,15 @@ config DRM_PARADE_PS8622
 	---help---
 	  Parade eDP-LVDS bridge chip driver.
 
+config DRM_PARADE_PS8640
+	tristate "Parade PS8640 MIPI DSI to eDP Converter"
+	depends on OF && I2C
+	select DRM_KMS_HELPER
+	select DRM_MIPI_DSI
+	select DRM_PANEL
+	---help---
+	  Choose this option if you have PS8640 for display
+	  The PS8640 is a high-performance and low-power
+	  MIPI DSI to eDP converter
+
 endmenu

diff --git a/drivers/gpu/drm/bridge/Makefile b/drivers/gpu/drm/bridge/Makefile
index f13c33d..fbe38dc 100644
--- a/drivers/gpu/drm/bridge/Makefile
+++ b/drivers/gpu/drm/bridge/Makefile

@@ -4,3 +4,4 @@ obj-$(CONFIG_DRM_DW_HDMI) += dw-hdmi.o
 obj-$(CONFIG_DRM_DW_HDMI_AHB_AUDIO) += dw-hdmi-ahb-audio.o
 obj-$(CONFIG_DRM_NXP_PTN3460) += nxp-ptn3460.o
 obj-$(CONFIG_DRM_PARADE_PS8622) += parade-ps8622.o
+obj-$(CONFIG_DRM_PARADE_PS8640) += parade-ps8640.o

diff --git a/drivers/gpu/drm/bridge/parade-ps8640.c b/drivers/gpu/drm/bridge/parade-ps8640.c
new file mode 100644
index 0000000..5f27548
--- /dev/null
+++ b/drivers/gpu/drm/bridge/parade-ps8640.c

@@ -0,0 +1,1057 @@
+/*
+ * Copyright (c) 2014 MediaTek Inc.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ */
+
+#include <linux/delay.h>
+#include <linux/err.h>
+#include <linux/firmware.h>
+#include <linux/gpio.h>
+#include <linux/gpio/consumer.h>
+#include <linux/i2c.h>
+#include <linux/module.h>
+#include <linux/of.h>
+#include <linux/of_gpio.h>
+#include <linux/of_graph.h>
+#include <linux/regulator/consumer.h>
+#include <asm/unaligned.h>
+#include <drm/drm_panel.h>
+
+#include <drmP.h>
+#include <drm_atomic_helper.h>
+#include <drm_crtc_helper.h>
+#include <drm_crtc.h>
+#include <drm_edid.h>
+#include <drm_mipi_dsi.h>
+
+#define PAGE2_SPI_CFG3		0x82
+#define I2C_TO_SPI_RESET	0x20
+#define PAGE2_ROMADD_BYTE1	0x8e
+#define PAGE2_ROMADD_BYTE2	0x8f
+#define PAGE2_SWSPI_WDATA	0x90
+#define PAGE2_SWSPI_RDATA	0x91
+#define PAGE2_SWSPI_LEN		0x92
+#define PAGE2_SWSPI_CTL		0x93
+#define TRIGGER_NO_READBACK	0x05
+#define TRIGGER_READBACK	0x01
+#define PAGE2_SPI_STATUS	0x9e
+#define PAGE2_GPIO_L		0xa6
+#define PAGE2_GPIO_H		0xa7
+#define PS_GPIO9		BIT(1)
+#define PAGE2_IROM_CTRL		0xb0
+#define IROM_ENABLE		0xc0
+#define IROM_DISABLE		0x80
+#define PAGE2_SW_REST		0xbc
+#define SPI_SW_RESET		BIT(7)
+#define MPU_SW_RESET		BIT(6)
+#define PAGE2_ENCTLSPI_WR	0xda
+#define PAGE2_I2C_BYPASS	0xea
+#define I2C_BYPASS_EN		0xd0
+#define PAGE3_SET_ADD		0xfe
+#define PAGE3_SET_VAL		0xff
+#define VDO_CTL_ADD		0x13
+#define VDO_DIS			0x18
+#define VDO_EN			0x1c
+#define PAGE4_REV_L		0xf0
+#define PAGE4_REV_H		0xf1
+#define PAGE4_CHIP_L		0xf2
+#define PAGE4_CHIP_H		0xf3
+
+/* Firmware */
+#define SPI_MAX_RETRY_CNT	8
+#define PS_FW_NAME		"ps864x_fw.bin"
+
+#define FW_CHIP_ID_OFFSET	0
+#define FW_VERSION_OFFSET	2
+#define EDID_I2C_ADDR		0x50
+
+#define WRITE_STATUS_REG_CMD	0x01
+#define READ_STATUS_REG_CMD	0x05
+#define CLEAR_ALL_PROTECT	0x00
+#define BLK_PROTECT_BITS	0x0c
+#define STATUS_REG_PROTECT	BIT(7)
+#define WRITE_ENABLE_CMD	0x06
+#define CHIP_ERASE_CMD		0xc7
+
+#define bridge_to_ps8640(e)	container_of(e, struct ps8640, bridge)
+#define connector_to_ps8640(e)	container_of(e, struct ps8640, connector)
+
+struct ps8640_info {
+	u8 family_id;
+	u8 variant_id;
+	u16 version;
+};
+
+struct ps8640 {
+	struct drm_connector connector;
+	struct drm_bridge bridge;
+	struct edid *edid;
+	struct mipi_dsi_device dsi;
+	struct i2c_client *page[8];
+	struct i2c_client *ddc_i2c;
+	struct regulator_bulk_data supplies[2];
+	struct drm_panel *panel;
+	struct gpio_desc *gpio_rst_n;
+	struct gpio_desc *gpio_slp_n;
+	struct gpio_desc *gpio_mode_sel_n;
+	bool enabled;
+
+	/* firmware file info */
+	bool in_fw_update;
+	struct ps8640_info info;
+};
+
+static const u8 enc_ctrl_code[6] = {0xaa, 0x55, 0x50, 0x41, 0x52, 0x44};
+
+static int ps8640_read(struct i2c_client *client, u8 reg, u8 *data,
+		       u16 data_len)
+{
+	int ret;
+	struct i2c_msg msgs[] = {
+		{
+		 .addr = client->addr,
+		 .flags = 0,
+		 .len = 1,
+		 .buf = &reg,
+		 },
+		{
+		 .addr = client->addr,
+		 .flags = I2C_M_RD,
+		 .len = data_len,
+		 .buf = data,
+		 }
+	};
+
+	ret = i2c_transfer(client->adapter, msgs, 2);
+
+	if (ret == 2)
+		return 0;
+	if (ret < 0)
+		return ret;
+	else
+		return -EIO;
+}
+
+static int ps8640_write_bytes(struct i2c_client *client, u8 *data,
+			      u16 data_len)
+{
+	int ret;
+	struct i2c_msg msg;
+
+	msg.addr = client->addr;
+	msg.flags = 0;
+	msg.len = data_len;
+	msg.buf = data;
+
+	ret = i2c_transfer(client->adapter, &msg, 1);
+	if (ret == 1)
+		return 0;
+	if (ret < 0)
+		return ret;
+	else
+		return -EIO;
+}
+
+static int ps8640_write_byte(struct i2c_client *client, u8 reg,  u8 data)
+{
+	int ret;
+	struct i2c_msg msg;
+	u8 buf[] = {reg, data};
+
+	msg.addr = client->addr;
+	msg.flags = 0;
+	msg.len = sizeof(buf);
+	msg.buf = buf;
+
+	ret = i2c_transfer(client->adapter, &msg, 1);
+	if (ret == 1)
+		return 0;
+	if (ret < 0)
+		return ret;
+	else
+		return -EIO;
+}
+
+static void ps8640_get_mcu_fw_version(struct ps8640 *ps_bridge)
+{
+	struct i2c_client *client = ps_bridge->page[5];
+	u8 fw_ver[2];
+
+	ps8640_read(client, 0x4, fw_ver, 2);
+	ps_bridge->info.version = (fw_ver[0] << 8) | fw_ver[1];
+
+	DRM_INFO_ONCE("ps8640 rom fw version %d.%d\n", fw_ver[0], fw_ver[1]);
+}
+
+static int ps8640_bridge_enable(struct ps8640 *ps_bridge)
+{
+	struct i2c_client *client = ps_bridge->page[3];
+	u8 vdo_ctrl_buf[3] = {PAGE3_SET_ADD, VDO_CTL_ADD, VDO_EN};
+
+	return ps8640_write_bytes(client, vdo_ctrl_buf, 3);
+}
+
+static int ps8640_bridge_disable(struct ps8640 *ps_bridge)
+{
+	struct i2c_client *client = ps_bridge->page[3];
+	u8 vdo_ctrl_buf[3] = {PAGE3_SET_ADD, VDO_CTL_ADD, VDO_DIS};
+
+	return ps8640_write_bytes(client, vdo_ctrl_buf, 3);
+}
+
+static void ps8640_pre_enable(struct drm_bridge *bridge)
+{
+	struct ps8640 *ps_bridge = bridge_to_ps8640(bridge);
+	struct i2c_client *client = ps_bridge->page[2];
+	int err, retry_cnt = 0;
+	u8 set_vdo_done;
+
+	if (ps_bridge->in_fw_update)
+		return;
+
+	if (ps_bridge->enabled)
+		return;
+
+	err = drm_panel_prepare(ps_bridge->panel);
+	if (err < 0) {
+		DRM_ERROR("failed to prepare panel: %d\n", err);
+		return;
+	}
+
+	gpiod_set_value(ps_bridge->gpio_slp_n, 1);