[PATCH v2 1/2] dt-bindings: GPIO: Add generic serializer binding
From: Andrew F. Davis <hidden>
Date: 2016-01-25 16:37:56
Also in:
linux-gpio, lkml
Subsystem:
gpio subsystem, open firmware and flattened device tree bindings, the rest · Maintainers:
Linus Walleij, Bartosz Golaszewski, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Add binding for generic parallel-in/serial-out shift register devices used as GPIO. Signed-off-by: Andrew F. Davis <redacted> --- .../devicetree/bindings/gpio/gpio-pisosr.txt | 34 ++++++++++++++++++++++ 1 file changed, 34 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/gpio-pisosr.txt
diff --git a/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt b/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt
new file mode 100644
index 0000000..e69e8ec
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt@@ -0,0 +1,34 @@ +Generic Parallel-in/Serial-out Shift Register GPIO Driver + +This binding describes generic parallel-in/serial-out shift register +devices that can be used for GPI (General Purpose Input). This includes +SN74165 serial-out shift registers and the SN65HVS88x series of +industrial serializers. + +Required properties: + - compatible : Should be "pisosr-gpio". + - gpio-controller : Marks the device node as a GPIO controller. + - #gpio-cells : Should be two. For consumer use see gpio.txt. + +Optional properties: + - ngpios : Number of GPIO lines, default is 8. + - load-gpios : GPIO pin specifier attached to load enable, this + pin is pulsed before reading from the device to + load input pin values into the the device. + +For other required and optional properties of SPI slave +nodes please refer to ../spi/spi-bus.txt. + +Example: + + sn65hvs882@0 { + compatible = "pisosr-gpio"; + gpio-controller; + #gpio-cells = <2>; + + load-gpios = <&gpio2 23 GPIO_ACTIVE_LOW>; + + reg = <0>; + spi-max-frequency = <1000000>; + spi-cpol; + };
--
2.7.0