On Thu, Sep 03, 2015 at 12:27:47PM +0800, Yakir Yang wrote:

Hi Rob,

在 09/03/2015 04:17 AM, Rob Herring 写道:

quoted

On Tue, Sep 1, 2015 at 1:14 AM, Yakir Yang [off-list ref] wrote:

quoted

Some edp screen do not have hpd signal, so we can't just return
failed when hpd plug in detect failed.

This is a property of the panel (or connector perhaps), so this
property should be located there. At least, it is a common issue and
not specific to this chip. We could have an HDMI connector and failed
to hook up HPD for example. A connector node is also where hpd-gpios
should be located instead (and are already defined by
../bindings/video/hdmi-connector.txt). Perhaps we need a eDP connector
binding, too.

Yep, I agree with your front point, it is a property of panel, not specific
to eDP controller, so this code should handle in connector logic.

From your description it sounds more like this is in fact a property of
the panel. Or maybe I should say "quirk". If the panel doesn't generate
the HPD signal, then that should be a property of the panel, not the
connector. The eDP specification mandates that connectors have a HPD
signal, though it allows the "HPD conductor in the connector cable" to
be omitted if not used by the source. I'd consider the cable to belong
to the panel rather than the connector, so absence of HPD, either
because the cable doesn't have the conductor or because the panel does
not generate the signal, should be a quirk of the panel.

That said you could have a panel that supports HPD connected via a cable
that doesn't transmit it, so this would be a per-board variant and hence
should be a device tree property rather than hard-coded in some panel
driver.

Conversely, if the panel isn't capable of generating an HPD signal, then
I don't think it would be appropriate to make it a DT property. It would
be better to hard-code it in the driver, lest someone forget to set the
property in DT and get stuck with a device that isn't operational.

Thierry