Hello.

On 07/07/2015 02:55 PM, Phil Edworthy wrote:

Instead of statically selecting the PHY connection to either the
USBHS (Function) or PCI0 (Host) IP blocks, this change allows the
dts to specifiy gpio pins for the vbus and id signals. Additional

    These GPIOs don't have anything to do with the PHY, they're interfacing 
Maxim MAX3355 OTG chip for which I have submitted the extcon driver.

gpio pins are used to control power to an external OTG device and
an override to turn vbus on/off.

Note: the R-Car USB PHY only allows this Host/Function switching
on channel 0.

This has been tested on a r8a7791 based Koelsch board, which uses
a MAX3355 device to supply vbus power when needed.

Signed-off-by: Phil Edworthy <redacted>

    I'm inclined to NAK this. You're modifying the wrong driver, I think.

WBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html