Re: [PATCH 1/2] Documentation: devicetree: Add TI BQ25890 bindings

Signed-off-by: Laurentiu Palcu <redacted>
---
 .../devicetree/bindings/power/bq25890.txt          | 45 ++++++++++++++++++++++
 1 file changed, 45 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/power/bq25890.txt

diff --git a/Documentation/devicetree/bindings/power/bq25890.txt b/Documentation/devicetree/bindings/power/bq25890.txt
new file mode 100644
index 0000000..44f50a7
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/bq25890.txt

@@ -0,0 +1,45 @@
+Binding for TI bq25890 Li-Ion Charger
+
+Required properties:
+- compatible: Should contain one of the following:
+    * "ti,bq25890"
+- reg: integer, i2c address of the device.
+- ti,battery-regulation-voltage: integer, maximum charging voltage (in uV);
+- ti,charge-current: integer, maximum charging current (in uA);
+- ti,termination-current: integer, charge will be terminated when current in
+    constant-voltage phase drops below this value (in uA);
+- ti,precharge-current: integer, maximum charge current during precharge
+    phase (in uA);
+- ti,minimum-sys-voltage: integer, when battery is charging and it is below
+    minimum system voltage, the system will be regulated above
+    minimum-sys-voltage setting (in uV);
+- ti,boost-voltage: integer, VBUS voltage level in boost mode (in uV);
+- ti,boost-max-current: integer, maximum allowed current draw in boost mode
+    (in uA).
+
+Optional properties:
+- ti,boost-low-freq: boolean, if present boost mode frequency will be 500kHz,
+    otherwise 1.5MHz;
+- ti,use-ilim-pin: boolean, if present the ILIM resistor will be used and the
+    input current will be the lower between the resistor setting and the IINLIM
+    register setting;
+- ti,thermal-regulation-threshold: integer, temperature above which the charge
+    current is lowered, to avoid overheating (in degrees Celsius);