Re: [PATCH v4 2/2] iio: vadc: Qualcomm SPMI PMIC voltage ADC driver

Ivan T. Ivanov schrieb am 12.11.2014 09:55:

On Tue, 2014-11-11 at 23:39 +0100, Hartmut Knaack wrote:

quoted

Ivan T. Ivanov schrieb am 11.11.2014 09:21:

quoted

Hi Hartmut,

On Mon, 2014-11-10 at 22:11 +0100, Hartmut Knaack wrote:

quoted

Ivan T. Ivanov schrieb am 03.11.2014 16:24:

quoted

From: Stanimir Varbanov <redacted>

The voltage ADC is peripheral of Qualcomm SPMI PMIC chips. It has
15 bits resolution and register space inside PMIC accessible across
SPMI bus.

The vadc driver registers itself through IIO interface.

Reviewing again, I got the feeling that due to the complexity of adc reads (writing to 
register
to start conversion, waiting a decent time for the conversion to complete, reading the 
result),
it would be beneficial to use a mutex in vadc_read_raw or its depending functions.

Hm, yes, but there is such a nice info_exist_lock :-) in core functions,
which in practice serve the same purpose.

I seem to miss that. Please point me in the right direction.

I am referring to info_exist_lock mutex part of struct iio_dev. 
It protects all operations inkern.c, no?

Good point, thanks for helping me there.

quoted

quoted

quoted

quoted

+
+       ret = of_property_read_u32(node, "reg", &res);

For u16, there would be of_property_read_u16().

quoted

+       if (ret < 0)
+       return -ENODEV;

Just return ret here?

I am usually trying to follow these recommendations[1]. In practice driver
core cares only for EPROBE_DEFER, ENODEV and ENXIO, while of_property_read_u32()
can return ENODATA and EOVERFLOW, which did't not make sense for the core.

Please point me in the right direction on this one, too. It is pretty common to pass error codes 
up, as it is also mentioned in [1].

Yes, I know that is common to just pass error codes up, but in this case it did't 
make too much sense, I think. Also take a look at realy_probe() and line 343.

This doesn't convince me. Actually, within the probe_failed part, it just doesn't care about ENODEV and ENXIO as long as debug messages are disabled (which apart from some developers, is default for the vast majority of devices). For all other error codes, it will at least print an info or warning about what's going wrong (and that can be a lot of help for debugging).

quoted

Yet, this thread in [1] seems more like a draft to me, as Greg K-H wrote in the end: "Fair 
enough, care to respin this and send it out to me for review?"

Yes, but it make sense to me.

Regards,
Ivan
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html