Re: [PATCH v3 2/2] ARM: dts: at_xdmac: add bindings documentation

diff --git a/Documentation/devicetree/bindings/dma/atmel-xdma.txt b/Documentation/devicetree/bindings/dma/atmel-xdma.txt
new file mode 100644
index 0000000..647f099
--- /dev/null
+++ b/Documentation/devicetree/bindings/dma/atmel-xdma.txt

@@ -0,0 +1,48 @@
+* Atmel Extensible Direct Memory Access Controller (XDMAC)
+
+* XDMA Controller
+Required properties:
+- compatible: Should be "atmel,<chip>-dma".
+- reg: Should contain DMA registers location and length.
+- interrupts: Should contain DMA interrupt.
+- #dma-cells: Must be <2>, used to represent the number of integer cells in
+the dmas property of client devices.
+  - The 1st cell specifies the memory interface (16 most significant bits) and
+  the peripheral interface (16 less significant bits) to use.
+  - The 2nd cell specifies the channel configuration register:
+    - bit 30-24: PERID, peripheral identifier.
+
+Example:
+
+dma1: dma-controller@f0004000 {
+	compatible = "atmel,sama5d4-dma";
+	reg = <0xf0004000 0x200>;
+	interrupts = <50 4 0>;
+	#dma-cells = <2>;
+};
+
+
+* DMA clients
+DMA clients connected to the Atmel XDMA controller must use the format
+described in the dma.txt file, using a two-cell specifier for each channel.
+The three cells in order are:
+1. A phandle pointing to the DMA controller.
+2. The memory interface (16 most significant bits), the peripheral interface
+(16 less significant bits).
+3. Channel configuration register. Configurable fields are:
+  - bit 30-24: PERID, peripheral identifier.
+
+Example:
+
+i2c2: i2c@f8024000 {
+	compatible = "atmel,at91sam9x5-i2c";
+	reg = <0xf8024000 0x4000>;
+	interrupts = <34 4 6>;
+	dmas = <&dma1
+		(AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1))
+		AT91_XDMAC_DT_PERID(6)>,
+	       <&dma1
+		(AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1))
+		AT91_XDMAC_DT_PERID(7)>;
+	dma-names = "tx", "rx";
+};

-- 
1.7.9.5